If your interior lights are not turning off, you probably have the override switch turned on. This is located in front headliner area and has a light icon on it. This switch forces the interior lights on, even when all of your doors are shut, or if you are driving.
Where is the front headliner area? I don't see a light icon on my 2011 Highlander.
Well I hit that light icon button and it fixed my problem! All the interior lights shut off. Thanks a bunch!!!
Good day please where did the icon light switch located in 2010 Toyota Highlander? and I don't really know what is icon light because I have the same problem in my Highlander 2010 the door light refuse to off when I close all the four doors and I tried to check all the switch the switch are working please I need assistance
×
If doors are not showing open, it's the dome switch that is turned on or bad.
Dome light switch or door switch
SOURCE: Interior Lights not workin on Dashboard/gear Shift
The problem is probably a blown fuse. Check the owner's manual for location of the fuse panel, find the fuse marked instrument panel (or similar), and put in a new fuse. If the new fuse blows, there is a short which will have to be located and repaired.
SOURCE: 2003 Toyota Highlander clock resets when I turn off the ignition
Have you checked any fuses? Does the climate control light up? If not then in the under hood fuse box (left of drivers side) check the ECU-B fuse should be 7.5 amp. Check the heater fuse in the fuse box inside the car it should be 15 amp. If the fuses are OK and only the clock is bad check out my site www.autoclockrepair.com I offer a repair service.
SOURCE: what causes a toyota highlander VCS warning
When your VSC (Vehicle Stability Control) light comes on, it means your car has been forced to take evasive action to avoid a dangerous situation. For example, if you're driving on an icy or wet, slippery road, and take a turn too sharp or accelerate too quickly, the vehicle will automatically reduce acceleration or apply pressure to the brakes to prevent the car from losing control. In this situation the VSC indicator light will light up to alert you that the action was taken, and remind you to slow down - or to be extra careful. Be safe!
SOURCE: how to clear airbag light 2011 toyota highlander
Usually you have to have the body computer cleared of codes before the light will go out.
SOURCE: 2002 Toyota highlander passenger brake light not working
RE: 2002 Toyota Highlander 2.4cyl. 4X4 Base Model
I am a Certified Technician and have basic knowledge with electronics in electrical wiring. I searched the web and discovered this is a common problem.
I fixed the problem and it was a simple procedure... The problem is with the reverse light socket at the side with no brake light. This socket functions as a hub to direct current to the brake bulbs.
Remove reverse light socket and re-seat bulb. Check for loose or broken prongs. Replace if necessary.
Swap the reverse socket with the other side.
20,729 views
Usually answered in minutes!
×