How to remove micra zs headlight - 2004 Nissan Nissan almera tino

Have you had a battery disconnect recently? Did you try resetting the the security system and engine immobilizer?

K12 SE AUTO,Removed Battery Terminal Now Car wont start

Micra Sports Club https://micra.org.uk > K12 General Discussion
Jan 4, 2023 - 1. Leave the ignition key in "ON" position for approximately 5 seconds. 2. Turn ignition key to "OFF" or "LOCK" position and wait approximately 5 seconds. 3.

K12 security indicator warning light on red - Micra Sports Club
Jan 6, 2023
K12 nats problems ' Micra Sports Club
May 8, 2020
K12 1.2 Non starter immobiliser ' Micra Sports Club
Mar 4, 2021
K12 (2004) Power Steering Fix - Micra Sports Club
Jan 9, 2023
More results from micra.org.uk

HOW TO: Reset ECU (Clear DTC codes) - Nissan Forum

NICOclub Forums https://forums.nicoclub.com > how-to-reset-ecu-clear-...
Aug 24, 2009 - 1. Turn ignition "ON" (without starting vehicle), count to 3 seconds. 2. Depress/Release accelerator pedal 5 times...hard and fast. 3. Count to ...

Security system reset - Nissan Forum
Oct 17, 2018
Immobilizer tripped? How to reset or figure out how to start car
Feb 22, 2020
More results from forums.nicoclub.com

It is on the passenger side under the hood towards the front of the car. Almost next to the headlight. Look for round yellow handle

http://tag.wonderhowto.com/remove-nissan-micra-door-panel/ http://tag.wonderhowto.com/remove-nissan-micra-door-panel/

power distribution box under the bonnet

the whole assemble or the inside bulb.
the bulb is covered in the glove box guide, lost that?

Great, Cars have a lot of relays.

Headlight relay.

look for a fuse box under the hood near the battery.

hi did you get the resistor fixed if not you need to remove the glove box by removing the screws that can be seen then there are two plastic lugs that need to be pulled out sideways to enable you to remove the glove box then you will see the resistor card on the side of the motor thats on the new shape micra k12

need to remove instrument cluster to get to globe from the back,should be mounting screws in front to remove around instruments