SOURCE: brake light switch
HI
IT WAS LOCATE IN UPPER OF THE BRAKE PEDAL
BEFORE YOU CHANGE IT CHECK FOR :-
STOP LAMP SWITCH AND ASCD CANCEL SWITCH CLEARANCE
1. Twist and pull to remove switch.
2. Pull up on brake pedal pad and hold.
3. Insert switch into retainer until switch plunger is completely depressed.
4. Turn the switch until it locks into place in the brake pedal bracket.
NOTE:
When turning the switch to lock into place, the switch backs off the stopper to the correct clearance automatically.
5. Release the brake pedal pad.
ASK ME FOR MORE ??
WITH MY BEST WISHES
SOURCE: 2003 Nissan Sentra Brake lights stay on
When you depress the brake pedal, the brake pedal will move away from the brake light switch and cause a close circuit and the brake lamps light up. There is a rubber bunk on the pedal which pushes against the brake light switch to shut it off when you release the brake pedal. Most likely this rubber bunk has either fallen off or disintegrated leaving a hole in the brake pedal so there is nothing to push against the switch to shut it off. Look up the brake pedal until you see the brake light switch, then depress the brake pedal to see if the rubber bunk is still there. It is easy to replace. Or you can use some double sided adhesive tape and a coin and stick the coin over the hole in the brake pedal.
SOURCE: brake light, 2008 Nissan Sentra
Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.
SOURCE: How do I change brake light bulb of Nissan Sentra 2008
Was able to complete this job successfully:
It's a little tricky to do without pictures, but I don't have any available right now.
150 views
Usually answered in minutes!
×