SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: how to replace 2000 buick century temperature actuator
First, what is the problem that you need to replace the actuator? Is the air flow from the vents not changing? If this is the problem, the actuator is inside the venting behind the control panel and is difficult to get to but is possible. Follow the hoses on back of temp controls to the actuator. There should be 2 small bolt screws to remove to change out actuator.
If this is for something else, let me know
SOURCE: 1991 Century Buick V6 starter replacement.
remove the positive battery cable from the post
remove the 3 wires from the starter and the two bolts holding the starter to the block.
reverse the procedure for installation.
Testimonial: "I know that there is usually only 2 bolts to remove a starter. I've identified one bolt but was not sure about the location of the other one. Thanks"
134 views
Usually answered in minutes!
×