SOURCE: Jeep wrangler Fuse box
i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck
SOURCE: What does the auto shut off fuse do? 92 Jeep Wrangler.
The auto shutdown relay in your vehicle is controlled by the computer. If the computer does not see a signal from the crank or cam sensor, it will turn off power to the relay which in turn shuts off power to the fuel and ignition system. Unlike those in many passenger vehicles, it's not connected to an impact sensor. (as jeeps are off road vehicles as well as being transportation, if they had an impact sensor, they would be prone to shutdown when traveling over rough off road terrain)
The fuses to the relay are affected by shorting or overload of any components they serve, or by a problem with the relay itself.
SOURCE: 2000 jeep wrangler fuse keeps blowing?? What do I
That or the wiring to it is shorted at some point. Remove the connection at the center back of the socket and replace the fuse--if ok, replace or repair the socket. If still blows fuse, check the wire you removed for damage near any metal object.
SOURCE: I have a 1997 Wrangler Sahara 4.0L I have a IOD
is it .54 or 54. It should be less than .1 total draw with key off
898 views
Usually answered in minutes!
×