Hi Ricky, I'm glad to help. Below is the possible causes for the P0344 code that you have.
Symptom:
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT
When Monitored and Set Condition:
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT
When Monitored: Engine running or Cranking.
Set Condition: When the failure counter reaches 20. One Trip Fault.
POSSIBLE CAUSES
GOOD TRIP EQUAL TO ZERO
WIRING HARNESS INSPECTION
(K7) 5 VOLT SUPPLY CIRCUIT OPEN OR SHORTED TO GROUND
TONE WHEEL/PULSE RING INSPECTION
CHECKING CKP SIGNAL WITH THE DRBIII
t LAB
CAMSHAFT POSITION SENSOR
(K44) CMP SIGNAL CIRCUIT OPEN
(K44) CMP SIGNAL CIRCUIT SHORT TO GROUND
(K44) CMP SIGNAL CIRCUIT SHORTED TO B+
(K44) CMP SIGNAL CIRCUIT SHORT TO (K7) 5 VOLTS
PCM
When you miss a notch on the timing belt the engine will idle but you will get a cam positioner fault code because the cam is not matched to the crank,
SOURCE: Do you have to remove the timing belt on a 95
yes replace the pump and timing belt at the same time. 99 percent of service technicians will tell you the same
SOURCE: replace dodge neon timing belt and water pump
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
Click on the following direct Link. It has several Diagrams you will need for your Timing Belt replacement. Included are the Cover Bolt Locations and Marks for your specific engine.
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies..
http://www.2carpros.com/car_repair_information/year/2002/make/dodge/model/neon/2002_dodge_neon_timing_belt_diagram_marks.htm
SOURCE: 96 dodge neon... just changed the timing belt and
you need a scanner that will perform the cam/crank relearn procedure. snap on's modis or solus will perform it.
SOURCE: What's the schedule replacement of the timing belt
80-100,000 is a good idea. absolutely replace the timing belt at the same time. it'soff anyway and soaked with coolant. cheap insurance!
SOURCE: Whenever I start my 2004
you have to check drive belt driving p/s pump the belt is loose or the tensioner is not applying enough tension
this will help to fix your problem plz let me know comment reply if you need more info
476 views
Usually answered in minutes!
×