I dropped my phone into the top of the dashboard of a 2008 jeep wrangler. how do i get it out

Did you test electrical circuit before replacing ?
P0032 Jeep O2 Sensor 1 1 Heater Circuit High

with a socket + universal and an extension?
you dont have full tools set?
which engine,? gas or diesel? 3.8L
my 2008 6speed, is yours 5 m.t or slush pump.>? a/t
on mine, its easy.
but cant answer with no engine stated or trans.
or car bodies are same ,for sure. 2door.? right>?

mine is 3.8L v6
i own a full FSM. too.
7400 pages.
the books shows removing battery neg lug, or boom.acid bath

then shield
then says remove starter. see the bolts there?
then as it drops down take of the solenoid wires.
its you hands.
it assumes you have full set of tools.
extensions, universals., and sockets.

but no engine options stated.or transmission.

google search images.


2008 Jeep Wrangler Rubicon diagrams



you will see many different diagrams.

you are prolly going to have to remove the top dash to get dont think that you just loosen it up u mite thoug id try to loosen it up first if not the worst thing ud have to do is take it off

Try taking the gauge cluster out and cleaning the connectors then apply some dielectric grease. this may help with the speedometer. to remove the gauge cluster, pop off the top vent cover (3 clips), then remove the knee guard under the steering wheel. After that you will see two screws holding down the bottom part of the gauge cluster and 2 more on the top. Hopes this helps!

turn jeep off...press gas peddle quickly 3 times..wait 15 seconds...turn car on. if it doesnt work, adjust the speed of pressing gas peddle.

U will need to replace the switch for wiper and turn signals, there is a broken contact inside the switch.

bleeding cluch 96 jeep