SOURCE: I have a 98 toyota Avalon. The fuse for the dome keeps blowing
I'd look for a direct short, possibly a bare wire that has rubbed insulation off.
Start at the lamp socket first and any switch that might be located at the dome light itself, see if you see anything.
Next I'd check the door switches and then selector switch on the dash.
After that, it's going to be trracing wires, not an easy job.
At
SOURCE: Toyota Avalon 120 amp main fuse removal.
you have to loosen the mounting bolts on the fuse panel and on the bottom side the fuse is held in by 2 8 millimeter bolts.
Testimonial: "Very helpful and exactly right. Saved my neighbor a towing charge to the dealer. His car is back up and running. Thank you!!! "
SOURCE: how do i replace a 120 amp fuse step by step on a
There are several fuse blocks. They are located in the engine
compartment, behind the right side kick panel, under the instrument
panel or behind the left side kick panel.
REPLACEMENT
If
any light or electrical component in the vehicle does not work, its
fuse may be blown. To determine the fuse that is the source of the
problem, look on the lid of the fuse box as it will give the name and
the circuit serviced by each fuse. To inspect a suspected blown fuse,
pull the fuse straight out with the pull-out tool and look at the fuse
carefully. If the thin wire that bridges the fuse terminals is broken,
the fuse is bad and must be replaced. On a good fuse, the wire will be
intact.
Sometimes it is difficult to make an accurate determination. If this is
the case, try replacing the fuse with one that you know is good. If the
fuse blows repeatedly, then this suggests that a short circuit lies
somewhere in the electrical system and you should have the system
checked.
Fig. Once the cover is removed from the fuse box, you can identify each fuse and relay
Fig. All circuit breakers and fuses pull out quick easily
When installing a new fuse, use one with the same amperage rating as
the one being replaced. To install the a new fuse, first turn off all
the electrical components and the ignition switch. Always use the fuse
pull-out tool and install the fuse straight. Twisting of the fuse could
cause the terminals to separate too much which may result in a bad
connection. It may be a good idea to purchase some extra fuses and put
them in the box in case of an emergency.
Fig. Relays can be removed by pulling them from the block
I hope helps with this (remember rated this help) Good luck.
SOURCE: How do I replace the
I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya
Gurus. Have a good look at the sources of the page. Go through
the sources to find your solution. Hope it will help.
View Count:7
SOURCE: Toyota 1995 Avalon. 15 Amp fuse for the Radio and
Your problem is likely a bare wire under the ash that is hitting metal when it moves. You'll have to open up the dash and trace out you wire harness, Start at the radio connection and work back looking for a bare spot in the insulation or maybe even jjust a crack in it. Tape it up and try to reposition it so it doesn't hit metal or chafe again. Hope this helps.
217 views
Usually answered in minutes!
×