My car will not start with the new battery. whats wrong?
SOURCE: Car dead with complete power but will not start.
starter to replace the starter on a cad u have to remove the intake
SOURCE: car will not start.
i have the same problem i took panel off of passnger side and hear clicking noise too my dad seems to think the motor is locked
SOURCE: clicking starter=car not starting
the battery is located under the rear seat, check battery connections. if connections are tight replace starter.
SOURCE: 2006 cadilac won't start one
Make sure the cables are clean where they connect,,and have the battery tested with a load tester,if it shows 12.9 that is good,but a lot of the times the battery will not have any amps,,then if all this checks out,try tapping on the starter to see if it will start up as you try to turn the key to start the engine.If the starter tries,or starts the engine ,then replace the stARTER.
SOURCE: car won't start. There was
I am the type that likes to jump start a car to troubleshoot it. If you jump start the car and it starts that tells you that the starter and engine is good and the problem is in your battery or alternator. If it doesn't start then I take the serpentine belt off and try to turn the engine with a large wrench. If it rotates, then I replace the starter and starter solenoid.
30 views
Usually answered in minutes!
×