Question about 2005 Peugeot 405

3 Answers

How do reset service light on peugeot partner van

Posted by on

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Peugeot Expert
  • 215 Answers

Perform the following

Turn the ignition off
Press and hold the milometer push button (the button for reset the miles mostly the right hand push button on the dash)
Turn on the ignition (do not start the car!)
Wait for the display countdown to reach 0
Release the milometer push button
Turn the ignition off.
Turn the ignition on and check that the correct mileage till the next service is displayed

Posted on Jun 13, 2009

  • Wahs Team Jan 24, 2010


    For si1968: Procedure for Boxer spanner light it is slightly different but not complicated. However, you should carry out any service that is due and then do a re-set procedure as follows:

    * Place the ignition key in the MAR position (1st notch) and wait until the spanner stops flashing,

    * Press the trip recorder re-set button for five seconds.

    -------The distance remaining to the next service is displayed-------.

    * Press the trip distance recorder zero reset button for five seconds to store the operation in the memory.



    Important:
    after this operation, if you wish to disconnect the battery, lock the vehicle and wait for at least five minutes, otherwise the zero re-set will not be registered.



    Sorry for late response but you should put your question in problems and not in solutions like here.

  • Wahs Team Jan 24, 2010

    For Boxer service light reset:



    * Place the ignition key in the MAR position (1st notch) and wait until the spanner stops flashing,

    * Press the trip recorder re-set button for five seconds.

    -------The distance remaining to the next service is displayed-------.

    * Press the trip distance recorder zero reset button for five seconds to store the operation in the memory.



×

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Hi,
i have a 2006 boxer with the 2.2hdi engine. just tried to reset the spanner using the method above but the spanner is still there.
any suggestions please?

Posted on Dec 30, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My odometer is not working at all. I serviced the car and it worked for a bit then stopped again. any ideas?

Posted on Sep 14, 2009

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Anonymous

  • 1 Answer

SOURCE: warning light

how can i get pictures of wot warning lights look like on peugeot partner van

Posted on Aug 23, 2008

1chris1

1chris1

  • 72 Answers

SOURCE: Peugeot Partner Van Brakes Drive Shaft

Check both sides of the discs if they are ok.If yes then quite possible that there is lots of brake dust between the discs and pads.

Posted on Aug 01, 2009

TLRogue

Craig Davies

  • 99 Answers

SOURCE: Peugeot Partner Fuel Pump Problem.

If that connection is leaking, then that is more than likely the problem. If fuel is leaking out, then air will leak in. When the van is left overnight, the fuel will run back down the fuel line to the tank, leaving air in the pipe. The fuel system must be completely air tight. Try slapping some grease around the connection and see if it starts in the morning. if it does then replace the connector and you have fixed the problem.

TL

Posted on Jan 28, 2009

Anonymous

  • 1 Answer

SOURCE: Peugeot Partner Van 51 Plate

hi change the preheaters

Posted on Feb 15, 2009

Anonymous

  • 1 Answer

SOURCE: cannot take casing off front side light bulb

I want to change the side-light bulb on my Citroen Picasso off side front. I can get the near side one off, but find it difficult to turn the bulb holder inserted in the head light lens. Should I use some outside help like a HAMMER? Pete

Posted on Oct 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the lens housing unit on a rear peugeot van ?


Can you get to the bulb from inside the van? You may not need to remove the whole assembly. The lens can't be removed by itself - it's part of a complete assembly - housing and lens in one unit.

Aug 06, 2014 | 2010 Peugeot Partner Grand

1 Answer

Peugeot partner van


Yes probably, it is causing it to slip. The longer you leave it, the quicker you will burn out the clutch.

Nov 29, 2017 | 2005 Peugeot Partner

1 Answer

How do I replace the bulbs in the radio display panel on my 2007 Peugeot Partner Van


you need two brackets .i made a pic .these are normal included,
in your manuel off the radio.puch them in the holes till you feel,
little resistants.then puch bolt sideways and the radio comes out.
am not sure if the bulbs are replaceble. 5a9905e7-8a87-4088-9e2c-7630794e0aa8.jpg

Mar 04, 2014 | 2007 Peugeot Partner HDi

1 Answer

Fitting trailer wiring to peugeot partner van. need to know van wiring colours, dont match trailers wiring colours


Hello, if you have a test light handy with a sharp tip on one side than, start with your parking lights on and check to see which wire it is, if you have a heavy bag of potatoes or similar, you can use this when it comes to the brake lights :)

Feb 18, 2011 | 2006 Peugeot 604

1 Answer

Cant find diagnostic port in peugeot partner


Look under dash near drivers door

Feb 25, 2010 | 2006 Peugeot 505

2 Answers

I have a 1996 peugeot partner 1.8 diesel van running problems


Better would have been to get the diesel injectors checked too.( Cleaned and calibrated )
Hope the injector pump timming is set correctly!

Jan 31, 2010 | 1991 Peugeot 405

1 Answer

Peugeot Partner 2005 - Check Engine Light ON


Try depressing the trip reset with the ignition switch in the off position then turn the ignition on with the reset still pressed, wait 20 secs or so and it should reset, if not then you need a code reader.

Aug 02, 2009 | 2005 Peugeot 405

1 Answer

Peugeot Partner Van Brakes Drive Shaft


Check both sides of the discs if they are ok.If yes then quite possible that there is lots of brake dust between the discs and pads.

Aug 01, 2009 | 2005 Peugeot 405

1 Answer

Cannot take casing off front side light bulb, need to change the bulb. Peugeot Partner van '02


I want to change the side-light bulb on my Citroen Picasso off side front. I can get the near side one off, but find it difficult to turn the bulb holder inserted in the head light lens. Should I use some outside help like a HAMMER? Pete

Mar 31, 2009 | 2006 Peugeot 604

1 Answer

Warning light


how can i get pictures of wot warning lights look like on peugeot partner van

Aug 22, 2008 | Peugeot 604 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

7,702 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

scj103

Level 2 Expert

104 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...