My car was running poorly then 3 codes pooped up all together. I reset my computer and it's been running fine for a day now, but I'm worried. Does anyone know what's going on so I can fix this before I'm stuck on the side of the road?
SYMPTOM
P0320 - NO CRANK REFERENCE SIGNAL AT PCM
WHEN MONITORED
With the ignition ON.
SET CONDITION
No signal from the Crankshaft Position Sensor is present during engine cranking, and at least 3 Camshaft Position Sensor signals have occurred.
POSSIBLE CAUSES
SYMPTOM
P0700 - EATX CONTROLLER DTC PRESENT
WHEN MONITORED
Ignition key ON, Continuously.
SET CONDITION
Any DTC sets in the Transmission Control Module.
POSSIBLE CAUSES
Might need to replace the ECM (Computer). I don't see how all of those things could go bad all at once.
1,083 views
Usually answered in minutes!
Thanks for the fast response. I was thinking that may be it. I also felt my transmission slip last week. On a related but separate issue I had a power steering sensor leaking, it sent fluid into my wires all the way to my computer 5 years ago, but the EMC was fine then. Also does it mean anything if 2 of the 3 codes stopped and now I'm just showing the PO725? I hope this extra information helps...
pete
did the abs light or any other lights come on?
×