SOURCE: 2002 toyota celica power door lock problem
Are you hearing any noises from the pass door when you activate the lock switch? If not, the power door lock solenoid has failed, and prob needs to be replaced. Pull the door panel & check to see if it is getting power to the solenoid in lock & unlock. If it has power, the solenoid is def bad.
SOURCE: replace the ignition switch for 1998 toyota corola
first, remove the steering wheel and then remove the top and bottom covers on the steering column
SOURCE: Power lock on driver side door does not work on2003 Toyota Celica
remove the door panel and change the solenoid on the inside of the door
SOURCE: 1998 Toyota Avalon with power door locks, front
Check this site out
you need the passenger side door lock assembly kit.
There is one posted for sale in the US on this site. just scroll down for the following information and link
Used 1998 Toyota Avalon passenger door lock assembly
1998 Toyota Avalon
passenger door lock assembly
this is the part that surrounds the lock driver side. Car color is green
cary, North Carolina 27513
The solenoid or actuator arm for the door lock assembly is probably not working to full spec.
Hope this helps.
SOURCE: Toyota corolla altis 2003, driver side power
I had the same problem with my 2002 Altis. I found a solution after a lot of research and reading in the web.
1. Remove the power window motor from the regulator (mechanism).
2. Reconnect the power motor to the electronic controller(switches).
3. Perform "Auto Down" an wait until the motor stops.
4. Put a mark in the motor gear.
5. Perform "Manual Up" slowly until the gears rotates around 6 times but not greater than 10 times.
6. Remove the motor from the electronic controller.
7. Re-assemble whole power window assembly.
66 views
Usually answered in minutes!
×