Cranks ok but will not start,
so no spark, right> (and actual test not guessing)
all spark plugs, dead each fails for spark, or just 1 or 2????
using a fresh test spark plug, case grounded?
behold i see dead spark at all cylinders example.
1: check all fuse first (always)
2: key on, CEL must glow, if not fix that first.
3: i insert the diagnostic jumper and key on and the CEL flashes codes.
4: I crank engine for 5 seconds,
5: i release key not off
6: i look at my CEL, it flashes and tell is if CMP or CKP are dead
via there own unique codes.
i bet now , you are on track.
SOURCE: Change a water pump
1. Remove negative battery cable
2. Open radiator valve - drain cooling system
3. Remove cooling fan and shroud
4. Remove belt
5. Remove water pump pulley from hub
6. Remove hoses from water pump
7. Loosen heater hose coolant return tube mounting bolt and nut.
8. Remove the tube. Lose the O-Ring.
9. Remove water pump mounting bolts
10. Loosen the clamp on the bypass hose.
11. Remove the hose as you pull the pump away from the engine.
Hope this helps
Mike
SOURCE: change a headlight assembly Jeep Grand Cherokee
Just need take off the screws; for details check the graphics and ilustrations in the Jeep ZJ Grand Cherokee Service Manual
Hope helps (remember rated this) Good luck..
SOURCE: speakers for 1994 jeep grand cherokee
6.5" in all the doors dash is wierd. 2.75" but i have been able to squeez in a 3.5"
Testimonial: "thank you so much, that helps me out as lot"
93 views
Usually answered in minutes!
×