You can do it. time consuming as with any repair at home.as long as you got repair manual & proper tools.if ur not sure go to autozone.com put in ur info .then you can view step by step instructions with pix under repair info.good luck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The information you need will be stamped on the old alternator! If you are doing the replacement yourself then you will have to take it out anyway! As long as auto zone have both.....take it out and make sure then purchase the new one!
Probably a problem with pinion shaft endplay. New shims would take care of it, but if you don't know how to work on rear ends, then finding a shop that does suspension work or the dealer would be your best options ( or some guy on craigslist if you want to gamble ) It's really not a difficult job, but it requires know how and you'll need to replace the rear differential fluid ( make sure you get the right stuff it the rear differential is limited slip )
This is no job for a novice. Take it to somebody that knows about these. NOT a simple job. You will need to replace water pump and tensioner also. http://www.youtube.com/watch?v=kjhNOVl1Tcc
It's a big job but nothing especially difficult (several hours at least). Recommend you buy or borrow (library?) a repair manual that has the procedure in it.
I just did this on an 06,not too difficult.Take off the cover and unscrew the 3 tiny Phillips head screws and undo the large nuts, pull off the rotors etc. Then it is pretty much standard as a front wheel drive vehicle.I replaced them both on mine and it cost me approx.500.00 bucks at N.A.P.A.
are they drums on the rear? if not you can do this. on the caliper there should be 2 bolts holding it on. loosen one and pull the other out. lift the caliper up or down remove pads open the master cylinder so that you can compres the piston on the caliper. if you dont open the master sylinder cap it will be very tough. replace pads. tighten bolts nice and snug. then with car off pump brakes till tough. make sure you fill the master sylinder up that way no air gets in to it. if you do you gonna have to bleed the brakes. if that happens start at the passenger side rear then driver side rear then passenger front then driver front. please lemme know if you need help or if i helpd at all
Hello;
First congratulations on buying a camaro. If you have the clutch replaced, cost is in the $500. range. Can you do it yourself depends on several factors. The transmission weighs around 75 pounds. Do yo have a hoist or going to do it on the ground? Are you mechanically inclined enogh to tackle the job? It is an easy straight forward job if you know what you are doing or can have someone help.
Let me kow if you have other questiions regarding this. I have done a lot of clutchs so I can answer your questions quickly.
Thanks;
Rich
RPM Northwest
idk for sure if its gonna be the same or not, but basically replacing a turbo is pulling some bolts and replacing some bolts, the only thing that i would recomend looking up would be the torque ratings for the bolts on the turbo, but you'll prolly be able to pull it off no problem
THANK'S
×