At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Code p0102 refers to mass air flow (MAF) sensor/volume air flow (VAF)sensor --low input===causes-- wiring short to ground---MAF/VAF sensor---ECM
replace sensor
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Question edited for a lot more clarity.
Question moved to model category.
The MAF sensor is mounted between the air filter and the throttle body. The MAF generates a signal that the PCM uses as a primary input for determining fuel control, and code P0102 is set when the PCM determines that this signal is below specification for a certain amount of time. Aug 17, 2023
Replace the CKP (Crankshaft Position) Sensor. Your car cannot tell that you are trying to start it, because it does not see RPM's from CKP sensor. Common problem.
P0102 is a Mass air flow code. If you recently installed a K&N air filter it is possible some oil from the filter has gotten onto the sensor and damaged it. This code does not mean the sensor is faulty though. You could have an intake air leak which would also cause the code.
Its a MAF code mass air flow sensor P0102 . The sensor isn't cheap but is vary important and dose have a good recore value so bring the old one back with you ita worth about 60 dollars . Its located between the air box where the air filter is and where the duct goes to the air horn ware the the main air intake is . Its held in the duct by clamps one on each side of the MAF and simple to replace , I t just costs about 100 dollars and thats with the recore
×