Check the wiring where it goes thru the bellows between the door pillar and the door. Continuous flexing has commonly caused wires to not only break, but the insulation can crack, and short out.(perhaps why your other battery went dead - a parasitic drain caused by this condition?) Secondly, find the bulkhead connector where the door wires connect in the kick panel opening and check for evidence of burning or melting.
Testimonial: "thanks for your advices. I will check it again and what if the bulkhead connector in the kick panel is burnt ? how can i replace it ?"
SOURCE: 2002 toyota celica power door lock problem
Are you hearing any noises from the pass door when you activate the lock switch? If not, the power door lock solenoid has failed, and prob needs to be replaced. Pull the door panel & check to see if it is getting power to the solenoid in lock & unlock. If it has power, the solenoid is def bad.
SOURCE: Toyota Camry power windows not working from master switch
Their are two fuses that power this system. One is a 15 amp gauge fuse and the other one is a 30 amp main power fuse. You can also check the power main relay, your ignition switch, or i could possibly be a fault in the wiring
SOURCE: Power lock on driver side door does not work on2003 Toyota Celica
remove the door panel and change the solenoid on the inside of the door
SOURCE: 97 Toyota Camry aut. door lock and dash clock not working properl
i HAD the same problem.... first check the fuse under the hood labeled 'dome' should be a 7.5A it is blown for sure... also if you are good with wiring and at working on cars look at the drivers side doo wiring (between the inside door jam and the drivers side floor... its the wiring that goes through the door to the cabin.... anyway you have to take off the door panel and remove a small cover on the floor of the drivers side.... now remove the two connectors that go to the wiring harness.... you should now be able to loosen the grommet and pull the wiring harness through the door via the speaker hole (you should have removed the speaker already) you now must inspect the wiring which is most likely frayed and/or broken now fix the wiring with some new wiring and crimp connectors and heat shrink your work.... should be good as new... have fun getting the wiring back through the door... it will be bigger due to the crimp on connectors etc..... i did a quick write up of this so i hope it is understandable
SOURCE: Camry 1996 automatic power lock doen't work, but windows work.
if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks
91 views
Usually answered in minutes!
×