- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
no body size told, extended cab or ????
ext cab is
BCM should be located on passenger side kick panel (under glove box to the right). You have to remove a panel.
2007 service manual remove it page, clear as day
There isn't one. The function is done by the Body Control Module (BCM) along with lots of other functions.
Where is the turn signal relay on a 2006 Chevy Colorado?
The turn signal is controlled by the BCM (Body Control Module) that is located at the passenger side kick panel.
May 21, 2014
dont need to remove bcm fuse to program a fob the bcm needs to be active to program standard for - unless you have remote start then needs to be flashed to your vin by dealer or an authorized shop this link is for the lock unlock standard fob https://itstillruns.com/program-colorado-key-fob-7191242.html
Just the one under the hood . What problem are you having ? The BCM - body control module controls ( supplies ) power to a lot of subsystems on your vehicle . The BCM has battery feeds from the under hood fuse / relay center The BCM inturn supplies subsystems with that battery power .
Sounds like the BCM is either defective or needs reprogramming. Since you are combining 3 trucks, were all working well before they became parts vehicles? In a collision, the electric wiring to the BCM may have been smashed and with "crossed" wires may have been erased or shorted.
You would swap BCM's and use the driveable one to get to the Dealer for reprogramming or Autozone, Advace, or Oreilys for a free scan.
something puts bcm into safe mode. take neg. battery cable off and touch it to pos. post for 30 sec. leave unconnected for 6 hrs then reconnect. should work after that. just did mine. dealer wanted 400$ to change door switch. doing this lets the bcm reset itself
O2 SENSORS LOCATED ON THE EXHAUST MANIFOLD AND ONE EXHAUST PIPE BEFORE CATALYTIC CONVERTER.RADIO NOT SHUTTING OFF PROBLEM IN THE BCM.THE WIPERS WONT SHUT OFF.PROBLEM IN THE WIPER MOTOR OR SWITCH.IF SEAT BELT LIGHT STAYS ON YOU HAVE A ELECTRICAL PROBLEM THIS WOULD BE A DEALERSHIP FIX.
your turn signals go thru the BODY CONTROL MODULE.its located on passenger side kick plate down where you feet are.i dont think that is problem ,but its is sometimes.i am not sure where sound comes from,i assume its behind the instrument cluster.BCM is like computer in your truck.turnsignal relay is in there.
×