Perform service on the information panel-what does this mean?

code p1788 refers to AT-3-2 timing/coasting clutch solenoid--open circuit during self test===causes--wiring--mechanical fault--engine performance---ECM
Take it to a mazda service centre and get more information so that you can make an informed decision

Hello: Here is a breakdown of the codes you have: 888 is the segment check which tells you the system can display all codes, E-52 tells you the battery has been disconnected. It tells you that an idle learn should be performed. This idle learn is a very long procedure, you need a Service manual to perform it. The F-31 means there is a communication problem between the fuel data panel and the BCM (body control module). Most likely a Fuel Data Panel, but it could be wiring and/or a intermittent BCM. It would require intensive trouble shooting. 7.0 means the self diagnostic system is ready to go to the next step. If you go to Auto Zone or Advance Auto Parts you can buy a manual for your car (about 20.00 Dollars) I would like to be of more help but what you have requires hands on troubleshooting.

The SERVICE PERFORMANCE light is to let you know you vehicle is due for maintenance service. The light is set to light by mileage not set because there is something wrong. Your owner's manual will have what maintenance service should be done. Or if you let me know how mileage is I can get the information. Here is the procedure for resetting the light.

I think that the best service comes at a dealer, in general, but it's not always necessary to have service performed at the dealer, especially when trying to economize.

I couldn't find online information about the 2006 Volvo S40, so that means that buying the service manual should help to find the information that you require.

Good luck on choosing a service center for maintenance of your vehicle.

"perform service" have your mechanic reset it for the amount of mileage you would like to perform your next service...such as an oil chg in 3000 miles...

The service engine soon light is an indicator /reminder for you to do some type of maintanence work on your vehicle, depending upon your mileage that you have accumulated on your car dictates the sort of maintanence needed on the car.
Can either be as simple as an oil change or as complicated as a major service/tuneup, oil change, transmission change, wheel alignment, brake inspect, tire rotation etc.
Once the work is performed the technician must turn off the light.
Reference the dealership or reliable repair shop for further information.

It means that the car's computer (ECM) has detected an issue with your engine's performance and needs to be addressed. It could be as simple as a faulty gas cap to a bad O2 sensor that needs to be replaced, Auto Zone scan's car's free of charge to retrieve the DTC codes which will inform you what issues needs to be addressed and can give you instructions to address the issues to get your car's engine running at 100% again. Good luck and keep me posted, be glad to answer any more questions you many have.

Its telling you, according to a preset schedule, your vehicle is due for service. You might have already preformed needed services such as an oil change, but the computer was never reset. Your owners manual will specifically explain what to do and when to do it.

it is set to go off every 30000 miles. just scan to this where is shows 0 and press and hold the reset button until it changes to 30000. then get your oil changed.

Service intervals, service due.
Illuminates to indicate that routine
service should be performed. Check
your maintenance schedule to
determine the routine service to be
completed.
To reset the light, hold the SELECT
and UNITS controls on the trip
computer for five seconds. The light
will be illuminated and then extinguish after approximately four seconds.