ABS light stays on

The light being on means the system has detected a problem in one or more sensors. The vibration is the ABS modulating the brakes to prevent skidding because it has detected a wheel that is locked up. That wheel is most likely the one sensor that is giving you the error.

The regular brake warning light is for the parking brake being applied or the brake fluid is low. You would need to get the abs system scanned for trouble codes to proceed.

ABS is short for anti-lock braking system. This is a separate system from your hydraulic brakes.
The abs light means the system has a problem and it is disabled until you fix it. The regular brakes still work as you know.
Someone needs to scan the computer for ABS trouble codes and go from there.

the ABS light is on because there has been a fault detected by the ABS module. It has nothing to do with the actual braking system.

The ABS module does a self check every time you start the vehicle. If it detects a problem during that self check the ABS light will stay illuminated and a code or codes for the fault will be stored in the ABS module. Scanning the module will allow you to pull the codes and proceed with diagnosing why the fault is occurring.

The most common source of ABS problems is bad wheel speed sensors or broken wires to the wheel speed sensors. Again pulling the codes from the ABS module will narrow down the possibilities.

Once you now what codes are present post them and we will be happy to assist you further.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

This is a common issue, and is pretty easy to fix. There are ABS sensors on the wheels, and you have a bad one. Usually the wires become corroded, and are easy to spot. The unit is on the back side of the wheel assembly.

check for codes with scanner it most likely is the abs sensor on the rear differential housing that is bad easy fix

Get your ABS fixed. The airbag light can only be reset by a dealer. Usually caused by a bad or disconnected seat sensor

The code scanner that you need is called ODBII code reader with ABS, and it works in the same way as the one that you connect to the car computer module (ECU) to read codes when the check engine light comes on, but the cheap ones that you can buy from $50 do not have the ABS brake scan function.

If the problem is the ABS, then it is often a wiring to abs problem, or a defective ABS control module, a scan reading is necessary to know what the problem is.

Below few examples of Code reader with ABS:

Equus 3150 Innova ABS + Professional CanOBD2 ...


$199.00 - Amazon.com


Cp9449 Brake Scan Abs Diagnostic Tool Obd2 ...


$219.67 - eBay


Equus 3160 Innova ABS + Professional CanOBD2 ... $259.99 - Amazon.com


CAN OBDII Code Reader with Multilingual Menu $49.99 - Harbor Freight Tools

Need to have a code scanner hooked up to it to find out why the light comes on, that will identify the problem, might be one of the four wheel speed sensors.

THE EBCM IS BAD this is the electronic control module that is on abs pump. you can replace seperate I think it is around 500 for part