SOURCE: P0440 Evaporative Emission Control
You need a charcoal canister and vent control valve.
You also need the EGR solenoid valve (I think it the brown one).
Valve is located in the valley of the V, towards the transmission side of engine.
Do these 1st and reset light. You may have other issues but you have to start here.
SOURCE: car codes
When you have P0440, P0441 and P0446, it is a very good bet that the fuel cap was loose, or the fuel cap rubber seal is compromised. You will get all three of those codes every time that the cap is loose. Always make sure that the fuel cap is as tight as you can get it after you refuel.
SOURCE: OBD code 0401 (1997 Toyota Camry 4 cyl)
There is a VSV (vacuum switching valve) , usually mounted on the back side of engine block, under the intake manifold, as well as the map sensor, that can also cause that code if one or the other is faulty. It takes some pretty detailed troubleshooting to confirm this in some cases, so if that's not in your line of work, you may have to have it properly diagnosed, or take a 50/50 shot at which one first.
SOURCE: Check Engine code P1409
clean the egr valve port on intake use piece of clothes rack clean the built up carbon on inside of port.
2,333 views
Usually answered in minutes!
×