My brake warning light stays on all the time. I replaced the brake fluid level sensor in the master cylinder. It didn't help I checked the harness and it has juice going to it all the time unless it is shut off.Any suggestions . Fluid level is where it is supposed to be. Brakes work as they should.
SOURCE: abs on dashboard stays lit all the time.
The only way to know axactly what happen is with a diagnostic computer.
Because the ABS use a Speed sensor on each of the wheels.
Hydraulic selenoids on the ABS box or Module..
If the light is on. its mean the Anti Lock Brake System is inactive., You gonna brake like any car with no ABS.
I hope this information work for you.
SOURCE: brake light stays illuminated
u should just be able to twist the top off like opening a bottle, it should be marked on the side of the tank how much to put in just be sure not to put to much, for this can cause problems too. hope it helps
SOURCE: brake lights stay on all of the time, ABS light on when driving
You most likely need to replace your brake switch, which is a
a $8 part. If you look up along the brake peddle you will see it depressing a switch. on the end of that switch is a electrical connector that you can press on one side to remove.
Once removed your brake lights will be disconected and your ABS
light should go off. You then need to replace the switch that it pluged in to.
SOURCE: ABS light stays on
that has four wheel anti lock so your gonna need to either take all them off and clean ends it may correct the problem but more than likely your gonna have to take to a large shop that has abs computer to find which sensor is bad then correct the problem
69 views
Usually answered in minutes!
×