Have you reset the cpu to adjust it to the new sensors. Did you use genuine sensors as the cpu will not always recognise aftermarket units and reads them as faulty
SOURCE: 95 dakota cranks but wont start
Well I'm a chrysler master tech & this is a little odd. There's alot of things not in the question so here are mine. I'm assuming it's a 3.9 no 4wd. When did this happen? When you check for power do you have some one turn the key on while you check? If still no power then make sure all the fuses are good from the one under the hood to the one inside the cab. Next be sure to check the grounds. You'll need to by a manual like a Haynes in order to get a decent wiring diagram. In a worst case senario the main power box under the hood has an issue & the asd relay gets no power,hence no start. Ran into it on a 95 caravan & it took a week to figure it out & no replacement was available & I had to hard wire it so it would run. Hope this helps.
SOURCE: got a 92 dodge Dakota
Check the Auto Shutdown Relay (ASD) in engine power distribution box (left inner fender-under hood)
You should hear fuel pump for 15 sec after you turn on key
SOURCE: I have 2005 Nissan altima that wont start. It
Nissans are known to have problems with ignition coils which would not show up on code reader. I would start with that. Pull a plug and hold it to ground to see how strong the spark is while turning engine over. If the plugs are wet when you take them out then you can be sure it is in all probability related to coils.
SOURCE: my 2002 envoy won't start,
You say you have power at the relay, but what part of the relay? If you don't have 12V at the gray wire going to the pump, then maybe the relay is bad. Also check to see what voltage you have on the dark green/white wire, this controls the relay (should be 12V).
1,653 views
Usually answered in minutes!
×