2003 Dodge Neon Logo

Related Topics:

Anonymous Posted on Feb 13, 2013

I have missfire in #4 cylinder 2000 doge neon

Runs pretty rough ideal improves a little as the car worms up lack of power in all ranges

  • Anonymous Feb 13, 2013

    I ran diag test code #p-1684 came up?

×

1 Answer

Stephen

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Dodge Master 21,873 Answers
  • Posted on Feb 13, 2013
 Stephen
Dodge Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 22, 2012
Answers
21873
Questions
0
Helped
6210337
Points
67230

I'm not sure that is a valid trouble code for your car. The code for Dodge is for a wastegate solenoid which is normally used on turbo engines.
The miss could be ignition, fuel, or something mechanical.

5 Related Answers

jimmy

  • 17 Answers
  • Posted on Jul 01, 2009

SOURCE: 1995 Plymouth Neon Running rough now wont start

it could be, but first you might want to run a onboard dianostic. turn your key on and off (not to run position) 3 times, on the third time leave the key on your engine light will blink out codes.
(like for 12 it will blink once pause then blink 2 more times.) try this then let me know what the code is.
hope this helps

Ad

patrick

  • 64 Answers
  • Posted on Mar 30, 2010

SOURCE: 95 neon idle is rough reeplaced egr valve and still running rough

coil pack, mine did same.

Anonymous

  • 50 Answers
  • Posted on May 16, 2010

SOURCE: On a 1998 dodge stratus 2.4 ltr engine misfire

check compression,with engine running remove h/t leads 1 at a time to diagnose weak cylinder,check that cylinder has the same amount of spark ( jumps the same gap as others )try changing the plug from crook cylinder to a good one and note if miss follows that spark plug or stays with same cylinder,can do same with injectors but only perform one procedure at a time so you can determine which one works.

Anonymous

  • 395 Answers
  • Posted on May 23, 2010

SOURCE: 2003 DOGE NEON IGNITION .LIGHTS, POWER COMES ON

replace the ignition switch
The ignition switch is usually mounted to the steering column and is operated by a linkage rod.
NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.
f32-17gif.gif The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:

  • Remove the ignition switch wiring harness.
  • Unbolt it from its position.
  • Bolt the new switch into position.
  • Attach the witing harness.

Anonymous

  • 50 Answers
  • Posted on Oct 06, 2010

SOURCE: P0304 alarm on my 2000

P0304 means cyl 4 misfire check your plugs or leads on this cyl .

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Truck won't run on its own

Check your fuel pressure, early 2000 rams are notorious for fuel pump issues. They start but run rough or lack power.
Were the lean codes for both banks 1 and 2? (P0171 and P0174)
0helpful
2answers
0helpful
1answer

How to take off pulley tenison on an 2000 Doge Neon an 4 cylinder

There are some videos on youtube on how to take tension off of the belt and how to remove serpentine belts. I posted a video below.
Hope this is helpful :-)

-Scott

How To Replace Serpentine Belt EricTheCarGuy
0helpful
1answer

I have a 2002 Nissan Altima 3.5 SE About a week ago the check engine light came on, it started running rough, especially at idle. Computer diagnostic results showed missfire in cylinder 6. I replaced...

i would definately replace the coil. pretty certain that will solve your problem. do not drive with misfire or that can cause fruther damage such as catalyst failing, which is prety expensive.
0helpful
2answers

Check engine light flashing runs rough not firing on all cylinder2000 lincoln navigator with large triton engine Hooked up diagnnostic and it said 1. system too lean bank #2 2. Unable to bleed up fuel tank...

you may try your rotor button and distributor cap. and spark plug wires. try your map sensor also they tend to cause a lot of misfiring if they go bad.hope this helps.
2helpful
1answer

Check engine light flashing runs rough not firing on all cylinder

take of the fuel filter and blow it out. i had the same problem with a 2008 ford f150 5.4 v8.
0helpful
1answer

2000 lincoln navigator unable to bleed up fuel

I think I would try the easiest thing to fix and then see how much straightened out. The fuel tank vacuum will probably be a gas cap not on tight or defective or a gas vapor line has a hole in it. You may need a smoker to find that leak if the gascap is okay,

Bank 1 should have cylinders 1,2,3,4. Since 3 cylinders that are in the same bank are misfiring it must be lack of fuel or bad spark. The tester said that bank was lean. If the plugs were not firing it would be rich with unburned fuel. The tester also indicated the other fuel tank vacuum bleed problem.

You might try the power connector for the Bank 1 injectors or check the injector wiring for #2,3,and 4 to see if they are getting power.

Remember to clear the diagnostic meter to see if the trouble codes return. Would be interested in the outcome.
3helpful
2answers

98 ford expidition 4.6 codes current po171 po174 and has po304 and po308 veh idles little rough repaire vaccumat rear of throttle body,is this a lower plenium leak veh has 177,00 mileson it

hi guess your engine has lack of power also a rough tick over ?your codes tell me you are running lean on bank 1and2 this can be due to many things its a matter of checking of one at a time 1 a bad coolant temp sensor 2vacuum leak 3 dirty injectors also reach over the top of your engine behind the intake dead centre of the windscreen there is a 9odeg rubber elbox check for a hole if thats your problem its only 3usd good luck please rate this answer thanks pete
0helpful
2answers

1996 Plymouth Neon 2.0 installed new timeing belt and now car is only running on two cylinders, in cylinder two a missfire was detected and random multiple cylinder missfire

You have the timing belt off. If the engine computer sees the Crank sensor and the cam sensor don't line up, the engine computer will shut down two injectors. It sounds stupid, but trust me. I have seen this before.
Not finding what you are looking for?

138 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...