Free download of 2000 jeep wrangler users manual

SOURCE: 4wd problem jeep wrangler yj 1995

i just bought a used 97 CHEROKEE but i had the same problem, when i got to looking at it i found out the front driveshaft was shot, look at that, if its not it i would say its probably the transfer case especially with an older vehicle like that which is a very expenxive repair

SOURCE: Looking for Service Repair Manual Jeep Wrangler YJ

i have a 1988 jeep wrangler 6cyl with 5 speed transmission. I was shifting the jeep and it got stuck in third gear. We opened it up and saw that the linkage is aligned and everything is in place. I dont know what is wrong and what to do next. please help ....

SOURCE: Instructions for replacing 1997 Jeep Wrangler 6cyl

Its an easy job! Disconnect the battery first! That's very importand! Then disconnect the wiring pack from the ECU. Some models are equipt with snap-systems, other with a screw-system to remove the wiring connector from the ECU. If done, there are three or four screws that hold the ECU in place with the body. Remove the screws and you hold the ECU in your hands. To buy a new or rebuilt ECU, reffer to the numbers shown on the label at your Wranglers ECU in combination with the V.I.N. To connect the new ECU with the wiring pack, be careful with the connector! You need to put him in the right position to connect with the ECU. Do it slow and make sure the connector fits to all points. Otherwise you'll bake some contacts inside the connector.

Testimonial: "Thank you for your informative response, It was just what I needed."

SOURCE: how to change a 1999 jeep wrangler 4 wheel drive

IS YOUR 4X4 ACTUALLY ENGAGING, IF SO THEN THE BULB BEHIND CLUSTER IS MOST LIKELY BURNED OUT

SOURCE: 2006 jeep wrangler oil leaking from the front of the transmission

the problem with the leak is the rear main seal on the engine is blown and should be replaced and you can pick one of these up at any auto parts store