The brake lights are working okay but have problems starting the car but performance very good just wont turn over have to easy bump the car where is this located if it is the relay can you confirm the correct relay i would need to replace the glow plugs have been changed also but still flashing
SOURCE: No glow plug light, car turns over but won't start, no CEL or codes
I don't have the solution but a possible help in diagnosing. If you remove the water temperature sensor connector from the sensor, the glow plug light should stay on when you go to start the car. Try leaving it on for 15 seconds and then start the car. If it starts right away, it is your sensor. If it doesn't, the good luck.
The sensor is located on the right side of the engine near the top, at the back. It is in the coolant fitting directly behind the hose from the rad, just left of the thermostat. Be careful to disconnect the wires, and not remove the sensor, or you will loose a lot of coolant. The sensor is held in by a separate plastic clip, and the harness just has a little built in clip on the side. Hope you have small hands...
SOURCE: 52 plate golf gt tdi engine workshop warning came
no sounds daft but it is ur break light switch above the pedel u wont have any break lights when it is flashing just push the pedel with ur hand in front of pedel at the top just fiddle with it till it pops out if no joy with that it will need changing hope this helps
84 views
Usually answered in minutes!
×