Any awncers
SOURCE: no turn signals............
If you look under the dash on the left hand side you will see the fuse area, behind this you should see a large ( about 1 - 2 inch) black square block. These usually sell for about 10 - 15 dollars each at the local auto stores. This is a link to a picture of them. Carry this into your local parts store and put in the new one and you should be good to go.
Please let me know if I can offer further assistance! I hope you found my answer helpful - if you need clarification please just ask me!
SOURCE: My turn signals on my 2000 Durango have stopped
Its might be your turn signal relay, generly these are located in the steering colum. but its a cheap fix.
SOURCE: 2000 Dodge Durango SLT 4wd - turn signal is
these vehicles do not have flashers, it is the turn signal switch in the steering column it is called a multi-function switch!
That's where your problem is!!
SOURCE: 1997 dodge avenger turn signal probs and location
replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace
Turn on the Durango and check each of the four turn signals
to make sure that the bulbs are not burned out. If you find one that has gone
out, replace the bulb and retest the turn signals. When a bulb goes bad on this
circuit, the resulting operation can mimic a bad flasher or one that is
failing.
Locate the combination turn signal flasher and relay. It is
on the left end of the driver's dash. Open the access door and view the
collection of relays and fuses. At the left side of the mounting block is a
larger flasher and relay. This is the combination turn signal flasher and
relay.
Test
the relay by placing you finger on the relay housing and activating the turn
signal. If you have found the right one, you should feel a clicking as the turn
signal blinks. Remove the relay, replace with the new relay and close the
access door
.
Start the Durango and activate the turn signals to check that they each work. The light should turn on and should blink. Also, check the hazard lights to make sure they work.
271 views
Usually answered in minutes!
×