2003 GMC Yukon Denali Logo

Related Topics:

Posted on Jul 11, 2017

I have a 2000 Yukon XL throwing a 'Service Ride Control' message. It was up on a lift for an oil change yesterday and when we drove it home, the ride was as hard as all get-out. the station is

5 Related Answers

Anonymous

  • 94 Answers
  • Posted on Mar 16, 2009

SOURCE: 2005 gmc yukon xl denali service ride control

it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on May 13, 2009

SOURCE: 2003 GMC Yukon XL Denali Service Ride control info

leaking suspension air bags is the most common cause, but the system can be tested for trouble codes, I suggest u do so, only the dealer can do this, but guessing about what the problem is can get very expensive very fast.

Anonymous

  • 146 Answers
  • Posted on Jan 05, 2010

SOURCE: what does service ride control light on a Yukon XL

It means you should take it to the dealership so they can check the pressure in the system and reset the sensor.

NomadTrucker

Nomad

  • 166 Answers
  • Posted on Jun 30, 2011

SOURCE: I recently did a complete

Have you tried removing the Ride Control fuse (RTD - real time damping) so the system has to go through factory initialization again on power-up?

If this doesn't reset the system - it detects a condition on its sensors which causes it to trip and display "Service Ride control"

Anonymous

  • 1 Answer
  • Posted on Aug 31, 2011

SOURCE: Service Ride Control message on.

Message says service ride system

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Service ride control

You need to have it scanned for fault codes. A fault exists in the system activating the service ride control
0helpful
1answer

How to reset service lamp after oil change on a 2000 yukon gmc

I have a 2005 GMC Envoy and you turn the key to on, then press the gas pedal to the floor three time in 5 sec. The oil light blinks once and your done. I'd give it a try. Remember engine off but the key is on. Can't hurt to try it. Otherwise you'll need an owners manual to figure it out.
0helpful
1answer

Service ride light is on

you just need an oil change. when you take it to get serviced they clear the service light.. not unless its a check engine light then you need to put a scanner yo get the fault codes.....
1helpful
1answer

What does service ride control light on a Yukon XL Denali

It means you should take it to the dealership so they can check the pressure in the system and reset the sensor.
1helpful
1answer

2003 gmc yukon denali xl starts but gas not flowing engine could it be a loose gas cap or fuel pump. Fuel filter changed. Also what does service ride control mean Singlemom03

if your engine starts up and dies right away the you probably have a fuel pump problem and the service ride control mean that your air ride compressor has gone bad just turn your key to the on position and wait about 30 seconds you will here buzzing from the left rear wheel area if the compressor is working
9helpful
1answer

2003 GMC Yukon XL Denali Service Ride control info

leaking suspension air bags is the most common cause, but the system can be tested for trouble codes, I suggest u do so, only the dealer can do this, but guessing about what the problem is can get very expensive very fast.
9helpful
3answers

2005 gmc yukon xl denali service ride control

it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you
4helpful
1answer

2000 yukon xl

turn the key to the run position engine off, push the gas pedal all the way to the floor then release it 3 times within 5 seconds, the DIC will say oil life reset.
18helpful
4answers

Location of fuse box/panel for 2004 yukon denali xl

There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.

The ohter is under the dash and above the pedals, this one is much tougher to access.

Your Owner's Manual should tell you where the fuses are that you need to access.

Not finding what you are looking for?

197 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...