Renault espace V6, engine will not start, it was checked by obd, error code 5D- No engine rpm signal ?

Renault Scenic P242F Engine Trouble Code When the check engine light comes Renault Scenic P242F code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

Renault Scenic P242F Code Meaning :

P OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) O2 Sensor Heater Circuit Malfunction Turbocharger Boost Sensor A Circuit Low When you check Renault Scenic car engine light came on code P242F the reason should be . However manufacturer may have a different definition for the P242F OBD-II Diagnostic Powertrain (P) Trouble Code. So you should chech it on our car models. P242F Fault Symptoms :

1. Check engine light comes on
2. Engine stalling or misfiring
3. Engine performance issues
4. Car not starting

If one of these reasons for P242F code is occuring now you should check P242F repair processes.
Now don't ask yourself; What should you do with P242F code ?
The solution is here : Renault Scenic P242F Possible Solution : Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.
P242F OBD-II Diagnostic Powertrain (P) Trouble Code Description P242F OBD-II Trouble Code The Powertrain Control Module ( P242F code. Reason For P242F Code The reason of P242F OBD-II Engine Trouble Code is O2 Sensor Heater Circuit Malfunction. Parts or components should not be replaced with reference to only a P242F DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

Was the battery power lost to the radio?

If your stock engine ground strap is missing, you can install a nice big braided one between any good heavy engine bolt and the frame. As to no start, check fuel pressure with gauge, check for spark at plugs and ask again with this new info.

your code is 9655 man

The P1401 means you EGR ,exhaust gases recirculation is partially blocked.You need to access it and clean it.

Limp mode is when your car computer pick up a bad signal from one or more of your engine sensor's, limp mode is so you don't get stuck on the side of the road, have diag. done so they can pull code and check what's going on, hope this was very helpful.

they are prone to problems with the EGR valve sticking open, causing this, often black smoke is there too

I had a Renault Espace that did a similar thing when it was cold, The ECU thought that the engine was -40* according to the Renault engineer. There are two sensors located together on our Espace, it ended up being the temperature sensor next to the coolant temperature guage sensor located on the thermostat housing. I hope this is of use to you. Ian

if its working leave well alone,its a renault remember,topping up is done via the auto dip stick ,draining is done by slackening off the sump pan

with the ignition on press pull and hold the handbrake lever until the red light on it starts flashing