Tighten bumper 2002 volvo s40

Cylinder head bolts (D4192T2):

Cylinder head bolts are tightened in two stages. There is no need for retightening.
Follow the order as pictured.
Stage 1: Tighten to 30 Nm, Angle tighten to 50° ±4° in one movement without stopping.
Then wait at least three minutes in order for the cylinder head gasket to stabilise.
Stage 2: Completely loosen bolts 1 and 2. Tighten bolts 1 and 2 to 25 Nm. Angle tighten to 213° ±7° in one movement without stopping.
Repeat the Stage 2 for the remaining bolts in the order 3-4, 5-6, 7-8 and 9-10 as illustrated.

If you pull the trim off (use a plastic spatula to get under it, then just yank with your hands) there are holes in there to reach the bolts.

Get an extension and a socket, I think it's 12mm, and then see if you can just tighten them up a little bit.

Also, the bumpers hang on the body with some clips/grooves along the edges, so make sure that they didn't 'fall out' of the grooves and clips and sag that way.

If so, loosed the bolts, pull the bumper away from the car an inch or two and then push it back in place while aligning the bumpers edges.

Yes.
I see from pictures you have a plastic bumper.
These are held in place mostly with plastic clips that are fastened inside the fender where you cannot see them.
You will need to put the car up in the air to see what to do next.
Volvo dealers sell the clips, as so do a few car parts stores.
Those plastic bumpers are very poorly secured, and fall off easily on all cars.
You may also find ripped or torn plastic holes which is why it is falling off.
If you wish to fix it yourself, you may need to do some really "creative" work underneath the car.
God bless your efforts.

i believe you will have to try and attempt to fasten that bar with some sort of fastener i havea 2002 s40 ,but do not have the same problem

I have an owners manual in PDF that i can send you if you want. Email me at [email protected] with your make, model & year and i will be happy to email you a copy. I may have a service or haynes manual on PDF fomat as well but will need to make sure. If you email me for the owners manual if i do have the service manual i will send that as well just remind me to look. Have a great day.

where is the fuse for boot on volvo s40

Most surpentine belts have an atomatic tensoner. I have had 2 fail on different cars and it is a simple fix, both of them required removal of one bolt.

Due to the heat cause when breaking it can be difficult to remove so the best thing to do is leave the spray to penetrate for about ten minutes then go back and carefully apply pressure with a ratchet rather than a spanner.

try some volvo experts.

Hi Lowgate, you need to remove the front bumper for a start. Then the headlamp can easily be removed by removing the 4 10mm bolts that secure it.