2003 Hyundai Accent Logo

Related Topics:

A
Anonymous Posted on Jun 02, 2012

Where is fuel injector for 2003 hyundai accent

5 Related Answers

Anonymous

  • 962 Answers
  • Posted on Nov 26, 2008

SOURCE: AC works, Heater not working, 2003 Hyundai Accent.

Check the coolant level, do this with a cold engine. Or if you have recently used it. let it cool down for about 25 minutes before removing the radiator cap. if it is low, refill with coolant. If it does not, check your thermostat. Or better yet replace your thermostat. Be sure to get the right one . the same degrees as your old one. Just ask the teller to give you one for your engine size and car Model.And year.See where the radiator cap is. Then drain some coolant to where it will not spill from the radiator cap. Remove the hose nearest the radiator cap and you will get to the thermostat housing. Remove the housing and note how the thermostat is placed. Take of the thermostat housing and the old thermostat. Clean the housing and around the hole where the thermostat goes of any deposits. Get some grease and cover the new gasket with grease on the housing to hold it in place. replace the New thermostat and make sure it is flush with the engine and the housing. If it is off , you could break the housing upon tightening the housing.replace the hose and refill with coolant slowly to eliminate any air spaces.. Also check the coolant reservoir and fill it to the indicator line. Restart the car and chek for any leaks. Then check the heater after the engine heats up. If that does not do the job it could be the temperature sensor or the heater core.The heater core will take more time to check and clean or replace.

Ad

Anonymous

  • 566 Answers
  • Posted on Jan 08, 2009

SOURCE: hyundai accent, location of fuel cut off

hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention

Anonymous

  • 776 Answers
  • Posted on Jun 30, 2009

SOURCE: trying to find the fuel filter in a 2006 Hyundai Accent

YEP! It's in the fuel tank at the bottom of the fuel pump... it's called a 'SOCK.'

Anonymous

  • 1 Answer
  • Posted on Jul 22, 2009

SOURCE: replacing exterior door handle 2003 hyundai accent?

remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!

steve_e_uk

steve morris

  • 1675 Answers
  • Posted on May 22, 2010

SOURCE: Antifreeze for a 2003 Hyundai Accent

hi as this vehicle takes 6.5ltrs of liquid in the cooling system ( 1.6 16v based on ) as you did not give the engine size, but, 3.5ltrs of coolant is needed as it should be 50/50 depending on where you are and the temperature it has to deal with, warmer countries only need 30/70 That's 30 coolant to 70 water, but, if you are in a colder country it would be 80/20 that's 80 coolant to 20 water...and any standard coolant is ok no need for a specific one hope this helps please vote thanks

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Where is the fuel filter located in hyundai accent 2000

In order to locate the fuel filter in your accent, so check out this link 2005 Hyundai Accent Fuel Filter Location Wiring Forums
If the article didn't solve you issue, then check out this video which will guide you to change fuel filter in a 2003 Hyundai Xcent, have a look
0helpful
1answer

P0201,p0202,p0203

Malfunction in fuel injector circuits of injector 1, 2 & 3
1helpful
1answer

How to remove fuel injector in hyundai accent crdi

Remove injector pipes, then rocker cover and you will then see injectors inside, secured by a clamp and bolt on each cylinder.
0helpful
3answers

Where is the fuel pressure regulator on a 2002 Hyundai Accent? Is it above the fuel behind the driver's rear wheel or is it in the engine compartment? or some other place. thx.

Try this website to download a free manual



http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717
3helpful
2answers

I have hyundai accent 2003. While driving the engine died. Checked fuses,ignition,fuel pump(don't know if the pressure is right),starter is starting ok.

#1. Scan for trouble codes. If any, record them and let us know which ones they are.
#2. Connect a fuel gauge to the fuel delivery line at the engine... try to start the engine while monitoring fuel pressure... if there is fuel pressure (approx 35 to 50 lbs), the problem is elsewhere.
If no fuel pressure, check fuel pump relay, fuse, wiring to fuel pump connector (power & ground - use 12volt test light). If power & ground are present, problem is the pump (fuel filter is attached to the fuel pump inside the tank).
#3. Check injectors for injector pulse, check ignition coils for spark to spark plugs.
0helpful
2answers

Where is the fuel pump in a 2003 hyundai accent located?

Located in the fuel tank. it can be reached by removing the back seats.

Good luck.

Rate this.
0helpful
1answer

Why is my hyundai accent 1.5tdgsi fuel not pumping

first check if the pump is activating by opening the fuel tank and listening remember some one has to be turning the ignition switch if you here the pump the you have a fuel injector pulse problem if you don't here the pump then check your fuses and the relays if thats ok then check if you have power on the red wire in the fuel tank if thats ok then you need a fuel pump
1helpful
1answer

Where is fuel filter on 2003 hyuandai accent

remove the rear seat bottom cushion , and remove the fuel tank access cover , remove gas cap to relieve any pressure , remove ground strap and fuel lines from the filter , remove filter ,, to reinstall reverse procedure . cheers.
Not finding what you are looking for?

48 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...