How to replace power steering belt on 1977 corvette

Should be 3 belts

www.ask.com/v-belt/diagram/layout/1977/chevy/winnabago/350/cubic-inches/with/air-condition/

I suggest www.Willcox.com/Corvette . Great site.

I’m happy to assist further over the phone at https://www.6ya.com/expert/richard_9a19ee73dfa4686a

you bleed like you would the brake system. there is a bleeder screw on the slave cylinder that you bleed the system.

Power steering?

Hi Friend:
No Sir there should be 3-Bolts that loosen it, 1 Bolt is kinda hard to see ,its at the bottom of the pump,and another is on the backside.

Hope i've helped you sir.

From: d_hubbs

Its possible that something clogged up belt. One time, I had a baby kitten sleep inside my engiine and it knocked out the belt. Needless to say, I bang on my car now before I leave in the mornings.

check for power at the horn, the relay sends the ground

I have an 81 and it has 3

Crankshaft Balancer: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Release the accessory drive belt tensioner (3).
3. Remove the drive belt (5) from the engine.
4. Remove the power steering gear from the vehicle.
5. Remove the starter motor.
6. Remove the power steering cooler bolts from the front crossmember.
7. Remove the power steering cooler from the front crossmember and reposition.
8. Release the air conditioning (A/C) belt tensioner (10).
9. Remove the A/C drive belt (1) from the engine.
10. Remove the crankshaft balancer.
INSTALLATION PROCEDURE
1. Install the crankshaft balancer.
2. Install the A/C drive belt (1) to the engine.
3. Install the power steering gear.
4. Install the power steering cooler to the front crossmember.
5. Install the power steering cooler bolts.
^ Tighten the power steering bolts to 11 Nm (97 inch lbs.)
6. Install the starter motor.
7. Lower the vehicle.
8. Install the accessory drive belt (5) to the engine.
9. Connect the negative battery cable.
^ Tighten the negative battery cable bolt to 15 Nm (11 ft. lbs.).
10. Program the Transmitters.