Bulb replacement How are bulbs replaced in the Radio and the display for auto-climate read out??? In other words what and how to remove "covers" to make bulbs reachable? Thanks [email protected]

The bulbs are soldered in..they can be removed and replaced, it is just delicate work. Go to radio shack with an old bulb and the ones you need. There are 2 different types of bulbs..6 with blue rubber covers and 2 without and cover.. Good luck

The control panel for the heater and A/C must be removed. Suggest you get Chilton's manual from the library. It will take you through step by step with pictures. To summarize: 1) Remove trim panel covering radio and heater controls. 2) Remove radio. 3) Disconnect the two heater control cables from the control panel. The trick to removing the cables is to compress the "claw" spring holding the cable by pressing a screwdriver from the underside of the control panel to release each cable.4) Remove control panel. Take to a workbench. From the backside of the control panel at the top, notice two large holes through which you can access the V2 Toshiba bulb holders. Turn them a quarter turn to remove them and the bulbs. The bulb is a common #74 bulb.

yes they are they take the miniture bulbs to replace them you must remove the four screws holding them on from the back side 5/16ths to get them off then slide out and allow to drop down follow wires and twist sockets out to remoce aocket and replace bulbs, ther are 4 bulbs in the dash console for ac and heat.

the radio doesn't have a LED, it is a LCD, LCD display's have no light of there own, LED's do, the problem u have here is that the tiny bulb inside the radio behind the display is burned out, you need to pull the radio out and remove the top cover of the radio, right behind the display you will find a tiny twist in bulb socket, remove it and replace the bulb.

the radio display is lighted from the back by a miniature bulb, this is the problem, the filament is almost burned out or the bulb is loose in the socket, to replace this bulb u must remove the radio (requires special radio removal tool kit, about $6.00) and then the top cover off the radio, the bulb socket twists into the back of the display, you can buy the bulb at any parts store for about $2.00

the display is lighted by a tiny bulb inside the rado behind the display, u must pull the radio out and remove the top cover of the radio, there u will find a tiny bulb socket, twist it out and replace the bulb.

the radio display is lighted by a tiny bulb inside the radio, to change this u must remove the radio from the dash and take off the top sheet metal cover, under that u will see a small twist in bulb socket, replace that little bulb, the bulb is about $2 and avail at any full sevice auto parts store.

U must remove the climate control unit from the dash and remove the top cover of the unit, u will find a tiny twist in light bulb socket with a tiny little light bulb, this provides the backlight for the AC/heater display, u can buy the bulb at any auto parts store, couple of bucks.