2004 MALIBU CD CHANGER/ STUCK CD

Sounds like you need change your oil if it sits for awhile the lifter get stuck changing oil helps

My bros 2009 model had issues with the player too.. he bought some manual from a website somethng like reliable store i guess. manual was really cool, tho. was of help more than once

There may, or, may not be a small pinhole in the front panel of the changer. If it does have this hole, take a paper clip and insert it straight into the hole and this will enable manual ejection of the disk tray. If the hole is not there than the housing has to be removed to gain acess to the disks. Thank you, Dana

You will need to have the radio reset or checked out at the dealer.Ther could be a cd stuck in it.Or the radio/CD player may have be on when the battery power got to low.

hey there,
take a paper clip and straighten it out. then look for a tiny hole in the face of the cd and push the paperclip in until the cd comes out.

good luck
rick

can you remove the CD by opening up the face cover and using a pen or pencil push in on the release hole most are equipped with this feature if not maby tweezers and grab a hold of the edge of the CD itself and help it out while in eject mode

2001 honda accord with three cds stuck inside. Wont play or eject just a whooring sound and error on display. Any ideas before going to the dealer?

Have a 2005 Freelander and the battery died. When I re-charged the battery, the CD changer had a CD ERR 1 message. Could not eject or load a CD and the radio worked. I turned off the radio and pulled off the cover on top of the CD changer. I removed the two screws that hold the frame around the CD changer. I turned the CD back on and the CD went through a test on each CD. I know this solution might not work for everyone, but it worked for me

im sorry to tell you but it will have to come out to be cleaned and if it reads bad cd on every one the lazer usualy burns out. where is where i have had good luck M&R

I got the ERROR 3 on my Lexus RX330 2004 CD changer, and fixed this problem myself. My CD changer now works fine for more than one month after the repair, and hopefully will continue to work in the future )))) First, I opened top cover of changer ( about 8 screws ). Next step is most difficult - need to detach 4 tiny springs on top corners that hold metal top plate and keep them in the same place not allowing them to fall down (detach the spring, then hook the top with paper clip as to not let the bottom come detached and lose the spring inside). I used paper clips for holding the springs on the coners of the metal frame. Next need to take the metal plate out and then all plastic CD trays with CDs, the plastic trays may jam a little when being lifted out, but they will come out. Take all CDs and don't use them in the changer anymore. Seems the CD changer doesn't like CD-R's. So, use original CDs. Actually I an going to record new CD's using good blank media from good manufactures, will try to see whats gonna happen. So, take out all plastic CD trays keep them in order and facing the right way. After removing all CDs put all things back. Do everything very gently because all parts very precise and easy to break. The cd changer showed "Error 3" for the rest of the evening but then next day was fine and has been working fine since then. I think the computer had to be reset overnight to clear that error. If you have any questions, do not hesitate to PM me.