The car was running fine minus the windows going down. I took off the door panel to find the connection was not pluged in.when i plugged it in some windows came down then i put them up. Key was in the ignition on the on position. When i went to start the car it wouldnt even crank. I do here an electrical noise coming from the abs module but doubt it is that.
SOURCE: ABS/BRAKE warning lights always on in 2000 VW Passat
dont guess !! get it plugged into a scanner and see what the code is
SOURCE: vw passat 1.9tdi
the water in the footwell can make the wiring rotten check under the tape for any corrosion,i have changed a couple of units that have blown due to the water but it is a common fault
SOURCE: 2003 vw passat senstive abs
This is caused by excessive ABS sensor air gap. You might need to adjust the air gap on the speed sensor to the new cv shaft.
SOURCE: ABS/BRAKE warning lights always on in 2000 VW Passat
OKEY TRY TO GET A CODE WITH SCAN TOOL AND IF YOU CANNOT CONTACT WITH YOUR ECM YOU HAVE TO GET FIX YOUR ABS CONTROL UNIT.
BOSH ABS MODULE GIVES PROBLEM ON THAT MODELS I HAVE SAME PROBLEM WITH MY 1999 PASSAT V6 I SENDED MY PART TO GET FIX AND WAITING FOR THE COME BACK.
GOOD LUCK.
I DRAIN THE BRAKE FLUID FOR THE FIX LEAK FROM MY CALIPER AND I REMOVE THE ABS UNIT AND TAKE THE ELECTRONIC MODULE OUT AND SEND THE FOR THE REPAIR.
157 views
Usually answered in minutes!
×