2003 Buick Century Logo
A
Anonymous Posted on Oct 20, 2011

How to reset(clear) alarm "Change Oil soon." ?

1 Answer

ZJ Limited

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Buick Master 17,989 Answers
  • Posted on Oct 20, 2011
ZJ Limited
Buick Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 15, 2008
Answers
17989
Questions
0
Helped
14459380
Points
60858

This work at 2001, but you could try it:
To reset the "CHANGE OIL" light, turn the ignition switch to the run position with the engine off. Fully depress and release the accelerator pedal three times within 5 seconds. The light will flash twice and go out.

Hope this helps and just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer. Thank you for using FixYa.

Jose.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer
tip

Ford service light procedure 1994-01

Windstar

1999-01

To reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the message center, press the SETUP control to access the System Check mode. Press and release the RESET button until IF NEW OIL HOLD RESET is displayed. Press and hold RESET button until OIL LIFE SET TO 100% is displayed.


Windstar


1997-98

To reset "CHANGE OIL SOON/OIL CHANGE REQUIRED" message on the Message Center, press "RESET" and "SETUP" controls at the same time. "OIL LIFE % HOLD RESET NEW" will be displayed. Press the "SETUP" control to access the System Check mode. Press "RESET" to start the system check. Press and hold the "RESET" control. Press "RESET" and "SETUP" to reset the system to 100%


Explorer,
Mercury
Mountaineer


1997-01

To reset the oil life feature on the Message Center, press and hold the "OIL CHANGE RESET" button until the system counts down (about 5 seconds). The Message Center will display "OIL LIFE RESET TO 100%"


Probe

with Analog Dash

1989-92

When "SERVICE" is illuminated on the Vehicle Maintenance Monitor on the overhead console, press the "SERVICE INTERVAL RESET" button located directly above the light.


Probe

with Digital Dash

1989-92

When "SERVICE" is illuminated on the Vehicle Maintenance Monitor on the overhead console, press the "SERVICE INTERVAL RESET" button located directly above the light.


Probe

with Digital Dash

1989-92

When "SERVICE INTERVAL CHECK" is displayed is displayed on the far left side of the instrument panel, press the "SERV OFF" button, located on the speed alarm keyboard, until three tones sound.


Thunderbird,
Mercury Cougar

with System Scanner

1986-88

When "SERVICE" appears on the Diagnostic System Scanner, press the "ODO SEL" and "TRIP RESET" buttons simultaneously. The "SERVICE" message will go out and three short beeps will be heard when the system is reset.


Thunderbird,
Mercury Cougar


1989-94

If "CHANGE OIL SOON" or "NOW" is indicated on the Monitor, turn the ignition on, but do not start the engine. Within 16 seconds, insert a paper clip into the cavity to the left of the display and depress. The display will flash; when it stops, the system is reset.















0helpful
1answer

How to reset service reminder alarm on Toyota aurion 2008?

I am not familiar with that model but most Toyotas reset like this. Tune the key off. Pess and hold the odo/trip reset button while you turn the key to the run position (do not start the engine). The odometer should change to all dashes which will disappear one at a time then change to all zeros and then back to the mileage. Release the button as soon as the mileage is displayed. Sometimes the trip A needs to be displayed before you turn off the key to start. Your owners manual should have this info as well.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

4helpful
2answers

How to clear the change oil message in the information center on a 2004 Tahoe

GM OIL LIFE SYSTEM - RESETTING
Reset the oil life monitor when the oil has been changed, use the following procedure.
1. Turn the ignition key to the RUN position.
2. Fully push and release the accelerator pedal 3 times within 5 seconds.
3. If the Change Oil Soon light flashes, the system is resetting.
4. Start the vehicle.
5. The oil life will change to 100%.
6. If the Change Oil Soon light comes back on, the system has not reset. Repeat the procedure.
0helpful
1answer

How do I reset the "change oil soon" light on a

try turn the key to the position all the lights comes on dont start engine as soon as turn key on press gas pedal to the floor n release 3 times
0helpful
1answer

Service engine soon alarm

You may need to add oil or a oil change or a tune up If you had a oil change and notice the oil light was on the shop may have forgot to reset the computer
0helpful
1answer

How do you turn off the "CHANGE OIL SOON" light

For Buick Le Sabre, 1995-99, when "CHANGE OIL SOON" light is on:
  • Access the reset button in the glove box (refer to car manual if required).
  • With the engine off, set the ignition switch to the RUN position
  • Press and hold the reset button in the glove box for at least 5 seconds
  • The light should blink a few times (4) then go out!
Hope it helps: let me know how you go.
1helpful
2answers

My change oil light never goes off even though I had it changed and now my service vehicle soon light is on even though its been running fine

The change oil light needs to be reset after each oil change...some shops are not knowledgeable on how to do this...Your owners manual will instruct you how to reset the oil change light...The service engine soon is a catch all for low fluids and other needs...Be sure to check your oil level again...to clear the service engine soon light, you can disconnect either battery cable for 15 minutes then reconnect...if the service engine stays on...then you need to have your Grand Am checked...Auto Zone does a free diagnostic of check engine light codes...:)
14helpful
2answers

"service engine soon" light on

should have two lights check engine and service engine soon.check engine means there is a malfunction.service soon is reprogrammable,when you change you oil. check you owners manual for reset.

I’m happy to help further over the phone at https://www.6ya.com/expert/kenneth_3efc1f8510674f04

1helpful
2answers

I have a pontiac g6 and my change oil light has been on. i went and got a oil change and nothing happened and i cant see where to put the tRANSNISSION FLUID??

With the "CHANGE OIL SOON" message displayed, press any of the three DIC buttons to clear the "CHANGE OIL SOON" message. Display "OIL LIFE RESET" on the DIC. Press and hold the "ENTER" button for at least one second. An "ACKNOWLEDGED" display message will appear for three seconds or until the next button is pressed. This will tell you the system has been reset. Turn the ignition to "OFF". If the "CHANGE OIL SOON" message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure. on the 3.5 liter you have a dipstick near fire wall
Not finding what you are looking for?

462 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...