The slave cylinder on Saturn vehicles will be on the passenger side down by the wheel well, . The bleeder valve is a small screw with a hole in the top of it. --------- If you are replacing slave cylinder and you need more details,in that case click the link below for slave cylinder replacing details and diagrams:--- http://technoanswers.blogspot.com/2011/10/how-to-replace-clutch-slave-cylinder-on.html ---------- This should help.Thanks.Helpmech.
Thank you so much. I'm hoping it's quick fix. I've only had the car for 3 weeks and now I get to learn how to work on it. And being female I need all the help I can get. lol.
Yes its a quick fix, can be done at any local car garage.But after replacing the slave cylinder the air needs to be properly bleed.If the air locks are in there, then clutch problem will be noticed and also master cylinder can get faulty.
In most cases getting it replaced as a complete sealed unit is advisable.------
Thanks.Helpmech.
×
On a manual transmission the Clutch Slave Cylinder is located on the drivers side front of the transmission. You can locate it by first finding the clutch master cylinder on the drivers side of the firewall. Then fallow the plastic line to the front of the transmission.
To remove the slave you will first twist it then pull it out of the transmission.
The clutch slave and mater cylinder are replaced as an assembly.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: need to locate the starter location for a 1999 saturn sl2
It's on the backside of the motor if you stand on the drivers side and look down on the back side of the motor you can just see it the best way to get at it is put the car up on jack stands get under the car it's in the middle of the back of the motor.
Good luck
619 views
Usually answered in minutes!
×