I can't find spark plugs on my 2000 isuzu rodeo. Where you would expect them is an electrical connection but no plugs. It is a 6 cylinder. Does it have plugs and if so where are they?

Lt & Rt sides & Rr (Behind flywheel) of engine block,some may be located in cylinder head(S) as well.....V-6 ??

If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

Hello Harvey, My information shows firing order of 123456. #1 being passenger's front cylinder and #2 being driver's front cylinder.

you could swap one of the suspected injectors to one of the operating cylinders and see if the miss chances cylinder. are the clinders that are missing all on one bank or spread over the engine. also check that the injector electrical connectors are all the way home and clipped in . that should give you a bit of a start any how

Did you ever find out why? my amigo is not getting spark from the coil pack on cyl 2&3. It's a new coil pack and wires and plugs.and PCM. Still no spark from coil pack.

For the 1991 Isuzu Rodeo
I do not know if you have the 2.6L SOHC In-Line 4-Cylinder or the 3.1L V6; however I have included both below.

For the 2.6L:
Firing Order:
1-3-4-2
Cylinders:
(back)
...4
...3
...2
...1
(front)
Ignition Coils:
(back)
[///]1....2
[///]3....4
(front)

For the 3.1L:
Firing Order:
1-2-3-4-5-6
Cylinders:
.....(back)
5...............6
3...............4
1...............2
Distributor:
.....(back)
..............(+)-screw
.........4
..3
...................5
2
.................6
........1
(+)-screw
.....(front)
Rotation: Clockwise

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

My apologies for the delay....Due to the bad economy the number of questions posted has skyrocketed 50% in the last 4-months.

For 2WD and 4WD it is the same:
For 3.2L:
Firing Order:
1-2-3-4-5-6
Cylinders:
5-------6
3-------4
1-------2
(front of vehicle)
Coil is on the Spark Plug

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Where Is The Camshaft Position Sensor Located On A 1999 Isuzu Rodeo?

I do believe it is built into the ecm

Hi,
Isuzu seem to have complicated things by changing engines, firing orders and even direction of rotation! As you can see, they've numbered the cylinders the other way than the 3.2L.

The Firing sequence for the 3.1 (traditional distributor) 6 cylinder is as follows -



If you take the distributor cap off, there should be a "No.1" formed on the inside. Stick a lead on this before you put the cap back on and go from there.
As leads are different lengths, you may have to swap a few to find the best fit.

I think 2 of them will look out of place - but that's the way it's designed. Just make use of clips for holding them neatly.

Thanks for using Fixya.

Hi,

On the 3.2L distriburorless ignition, the firing order is a straight 1-2-3-4-5-6.

Cylinder numbering .

-

Hope this works for you