Tip & How-To about 1993 Jeep Grand Cherokee
If you have problem to start your car, especially in the morning may be
time to review the status of the battery and change it up.
To make this process requires that the engine is turned off like all the elements that consume power.
As the battery contains a flammable solution should work in well-ventilated area.
The steps to control and change the battery in your car are:
Step 1: Make sure that the battery needs replaced.
First check your appearance, if the battery has cracks or crevices definitely need to replace it.
Also check the condition of the terminals are the positive and
negative buttons that connect the cables from the alternator.
Sometimes, sulfur can corrode the terminals or prevent the current flow
to the engine, remove and clean the contacts guides can help solve the
problem.
If your battery is not maintenance free, you should periodically
review the level of liquid in it, lack of fluid can cause the loss of
battery power. To review the level open the lids to see if the solution
completely covers the internal plates, if you see only water and no
license plates then okay, otherwise add distilled water. If the battery
is discharged and must bring to bear.
In cases of extreme weather may freeze the liquid to return to work should bring it to a warm place for a thaw.
Step 2: Remove the battery
Once you have determined that you need to change or remove the
battery for charging, to remove the negative terminal, being careful
not to damage it, and then the positive, never the other way around as
if vapor electrolyte battery abroad This may be a blast. In addition,
make sure that the battery terminals do not make contact, once
disconnected, with the metal parts of the vehicle (cúbrelos with
insulation) and prevents it from touching them.
Now with the help of a key removes the setting of the battery, in this agárrela point firmly and remove it from the car.
It is important at this time to spend a little time to clean the
terminals and the tray with a solution of warm water and a little
baking soda. If necessary, use a wire brush or sandpaper to clean the
terminals.
Step 3: Place the new battery or recharged
When you buy a new battery, make sure it's the right size and
orientation. Most sellers can advise you if you tell the make and model
of vehicle.
Carefully place the new battery in the tray. Re-check that the
positive terminal of the right side. Connect the positive terminal in
the terminal, tighten and check that the setting is strong. Repeat the
same with the negative terminal.
At this point it would be good to put a layer of Vaseline around
the terminal to prevent oxidation. In stores you can find spare spray
products that perform the same function and do not accumulate dirt, but
are relatively expensive.
Step 4: Close the hood and turn on the car. Keep the engine running for a few minutes to take the battery fully charged.
Step 5: The old battery is highly toxic and must dispose of it
properly. The best solution is to bring a recycling center where they
recovered a small portion of the investment.
Good luck with this work...
3,055 views
Usually answered in minutes!
×