20 Most Recent 1991 Honda Prelude - Page 2 Questions & Answers

did you look in the cab fuse box yet?if they are good, try the under hood (enginebay) box.all cars.

Its the seal around your trunk is worn from time,

Your ingnition module might be bad or the crank shaft sensor. See if you have codes in you car

i have 91 honda prelude.and the speedometer is not working properly.what else can i find help.and look for to fix this problem

Go to your nearest Autozone or other parts house and buy an inexpensive plug gapper. I gap the Honda plugs at .045 .

u can find the answer in http://autorepair.about.com/--------------------------------------------------------------------------------------Mb Star C3

if its a cable clutch check cable and return spring, if hydrolic check oil and look for leaks

i would ck oil as break fluid in clutch cyl then bleed the air.you have no other problems.good luck.

It may not be the transmission, it could be the clutch or clutch pressure plate. Try double clutching (pump the clutch twice) before shifting.

There is usually a relay control center under the hood. Look for a black box, it will have a cover on it, should say on lid Relay center, the diagram will either be on outside of lid or under side of lid, it will tell you which one is the pump relay

I think you know enough, that there is no fix other than
removing the transaxle & doing a complete clutch service

You shouldn't have driven it at all for some time now
& you knew that as well,but it all has to come apart
& everything replaced, so it really didn't matter

No some day, when you own an automatic,you stop driving
it as soon as you can get it home or to a shop, or you
will ruin it in a matter of less than an hour,once they slip

You will need the flywheel machined or replaced
A new Clutch Pressure Plate
A New Clutch Disc
New Clutch Slave Cylinder & Throw out Brg

As I said trans has to come out first

Figure you may go as high as $1000.00

there is a cable mounted on the altanator farsten by a 12mm nut if that is broken or not hooked up
unit will not charge. use a tester to check for continuety or chech conection on battery harness

most shops will smoke test this problem, and will most likely be done by the hourly rate of that shop. average is between $65.00 to $85.00 an hour

Your speedo is not electric so it is driven by a cable. There is a problem in two locations. First is the cable itself not having the proper amount of grease and it is starting to fray. Second is the gear inside you speedo and it is worn out or some of the gear teeth is missing. Unfortunately there is not a quick fix. Good Luck