20 Most Recent 1996 Ford Crown Victoria - Page 6 Questions & Answers

Hi,
I'm a little confused. You want it to come on?
The check engine light comes on when you have a problem with the engine or drive train. If it hasn't come on, that's a good thing. It's not meant to be a reminder to check oil or anything like that.,, Please clarify? Thanks!

You will have to buy a new key cylinder. it's not to dificult and the cylinder should run you less than $30.00. at an auto parts store. you will have to remove some

I have a !996 C.V. with Police Package and it is a blown fuse in the 5 slot found under the dash........I had this happen frequently and it also causes my turn signals to stop working too. Make sure to use a 15amp fuse.....Hope this helped

i believe it is under the dash mounted to the top of the steering column

check the fuses in the fuse box.then you can try the signal lights to check the lights on the back.if they work then the bulbs are good.then check the brake switch on the bottom of the colume near the firewall.its not uncommon for a wire to brake and cause a problem.

Sounds like a really bad vacuum leak to me. Check the PCV hose where it goes in behind the throttle body. Those are notorious for the rubber elbows getting all mushy and imploding and getting large holes in them.

That is located on the keyless entry module on a paper tag. The module is in the trunk, either behind the side panel or under the rear package tray drop down.

This problem is caused by a heat damaged headlight switch and the connector to it, replace both parts, the connector is available as a repair part as well as the switch. When you replace the connector (A MUST DO!) SOLDER IT ON, NO SPLICE CONNECTORS! Shrink tube the connections. If you don't replace both parts then the new switch will quickly fail again and back to blinking headlights.

Its in the trunk in the fender well