1997 Mazda Pickup - Answered Questions & Fixed issues
Maxda B4000 RPM skips 2000 to 5000
If you can actually hear the engine race up to 5000 RPM you may have a serious problem. But more then likely you cant actually hear the engine rev up. If this is the case I would suspect a bad Tachometer ground wire.
8/23/2012 3:09:50 AM •
1997 Mazda...
•
Answered
on Aug 23, 2012
•
344 views
My dash lights and rear tail lights went out the
Hi, it's either the headlight switch or the tail lamp fuse. Check the fuse first. Sometimes using the wrong bulb will cause the fuse to burn out. It can also be a bad socket that burns the fuse.
9/3/2011 1:55:27 PM •
1997 Mazda...
•
Answered
on Sep 03, 2011
•
266 views
Front hub will not lock in on 4wd - all else works
im not familiar with truck but her are some ideas, when you say hub are you saying only one? does this truck have manual or auto hubs? If so, some times the hub grease gets to cold and will not allow the hub gears to slide or engage. Its possible that the drivetrain or 4x4 works but hub is stripped gear, use axle grease on bearings but use lithium grease on gear.
1/11/2011 6:52:28 AM •
1997 Mazda...
•
Answered
on Jan 11, 2011
•
262 views
Where is the fuel cut-off
Check the behind the kick panial on the passengers side, I think it is there but not 100 percent sure
11/29/2010 5:44:46 PM •
1997 Mazda...
•
Answered
on Nov 29, 2010
•
141 views
Find timing marks for a 1997 mozda pick up 2.3
the timing marks are located next to the top left side of the crank pulley. If you need further assistance please feel free to let me know by following up with a comment. Thanks, Midwest-tek
8/31/2010 8:14:38 PM •
1997 Mazda...
•
Answered
on Aug 31, 2010
•
84 views
Does this require dot 3 or dot 5 for the clutch
hello there:
this truck calls for the dot three fluid but will not hurt if you use the dot five it will perform just as well this will be a personal call on what you would like to use hope this helps you out thanks sincerely D.Jones
6/8/2010 5:13:24 PM •
1997 Mazda...
•
Answered
on Jun 08, 2010
•
66 views
Clutch safety switch
Find the location of the switch and cross the two wires together to start you engine. You can elimanate this switch by leaving the tow wires that connect to this switch by splicing the two together as I stated above
4/21/2010 1:14:33 AM •
1997 Mazda...
•
Answered
on Apr 21, 2010
•
187 views
1997 mazda 4000 4 litre missing all the time now
Check your spark plug leads,as this is often the cause of missfires,and check your spark plugs,you can use a multi meter and check for a varience in resistance to comfirm the problem
11/19/2009 11:56:38 PM •
1997 Mazda...
•
Answered
on Nov 19, 2009
•
74 views
Not finding what you are looking for?