20 Most Recent 2003 Ford Mustang - Page 8 Questions & Answers

0helpful
1answer

2003 Mustang Oil Leak

i may say it came from loose oil drain plug or the oil filter(if it's change). and maybe the technician forgot to torque or put gasket on the plug and tighten the filter.
2/24/2012 6:36:10 AM • 2003 Ford... • Answered on Feb 24, 2012
0answers
0helpful
2answers

Why isnt cylinder 1 and 5 firing on a 2003 ford

First check for worn sparkplugs and if they still god then check for spark on those cylinders by pulling the sparkplug wire off and cranking the engine over.If there is no spark then replace the coil.If there is spark i would have the injectors leaned.
1/14/2012 1:04:36 PM • 2003 Ford... • Answered on Jan 14, 2012
0helpful
1answer

Spark #3 not firing

Bad coil most likely!! Hope this helps good luck!!
12/23/2011 9:39:27 PM • 2003 Ford... • Answered on Dec 23, 2011
0helpful
1answer

Can u check codes if ur engine light is not on

bring it to any parts place for free--but codes dont tell the real solution--a scan that runs a data stream targets it
12/13/2011 4:53:12 PM • 2003 Ford... • Answered on Dec 13, 2011
0helpful
1answer

My '03 Stang GT won't start. I turn the key and nothing. It has 30g miles, and a friend said it is probably a fuse, not the battery. A jump start did not help. Any ideas?

I believe those vehicles have a spade terminal on the starter it has a plastic square covering on it grab it and wiggle it and pull and push it than try to start those connectors get corroded and dirty!
11/30/2011 1:42:23 AM • 2003 Ford... • Answered on Nov 30, 2011
0helpful
1answer

Cant find fuse fo ac no manual w/car

You can go to Ford.com and download an electronic owners manual. Use the support link at the top of the main web page then select owners manual and fill in the appropriate information.
11/30/2011 12:12:39 AM • 2003 Ford... • Answered on Nov 30, 2011
0helpful
1answer

Mustang 2003 check engine light on. Had diagnostic

If the light is flashing - NO. It means you are dumping raw fuel intot eh catalytic converter (very expensive).

If steady, drive sparingly.

01 is cylinder #1 misfiring. Could be spark plug or coil.

16 is misfire detected during start up.
11/3/2011 11:59:12 AM • 2003 Ford... • Answered on Nov 03, 2011
0helpful
1answer

MY AC ON 2003 FORD

The most common cause for an AC blowing hot air is the system is low on refrigerant. A small leak will eventually lose refrigerant until the compressor eventually will shut down. Most compressors require a minimum of 20psi to engage and chill the air. Most certified service stations can diagnose and recharge most systems for $100-150 depending on where the leak is. There are do it yourself kits available at most auto parts stores that come complete with leak detector (R-134A with dye to show where leaks are) compressor oil, and a recharge hose.
9/23/2011 1:31:03 AM • 2003 Ford... • Answered on Sep 23, 2011
0helpful
1answer

2003 ford with a mach

Good Day!

Please look for the serial and post it here, so I can give you the code.
The serial can be found stick in the body frame of the radio
9/16/2011 1:27:20 AM • 2003 Ford... • Answered on Sep 16, 2011
0helpful
1answer

2003 ford mustang gt with

get a new one not worth paying to fix ???? ebay??
9/8/2011 12:11:20 AM • 2003 Ford... • Answered on Sep 08, 2011
0helpful
1answer

Radiator only coolant tube got disconnected so the

I think your talking about the recovery tank hose. If so, just shove it back on the fitting, and clamp it. If the fitting is what has broken you may have to replace the recovery tank or the radiator.
8/27/2011 1:35:01 AM • 2003 Ford... • Answered on Aug 27, 2011
0helpful
1answer

Need fuse diagram for 2003 ford mustang v-6 need

Which A/C fuse are you looking for? There are 4 of them. F2.2 (20 Amp), F2.23 (15 Amp), F2.24 (30 Amp) are all located in the Central Junction Box behind the dash panel on the left-hand (driver's) side of the vehicle.
Fuse F1.24 (20 Amp) is also part of the A/C system and is located in the Battery Junction Block in the engine compartment.

If your A/C is not working, you should scaPowertrain Control Module (PCM) and your Constant Control Relay Module (CCRM). The first thing you should do if your A/C is not working is to scan your computer system for fault codes.

Please also review this article:
Where's The Fuse?
8/25/2011 12:15:50 AM • 2003 Ford... • Answered on Aug 25, 2011
0answers
Not finding what you are looking for?

594 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Mustang
1998 Ford Mustang

706 Questions

2000 Ford Mustang
2000 Ford Mustang

694 Questions

2001 Ford Mustang
2001 Ford Mustang

653 Questions

1995 Ford Mustang
1995 Ford Mustang

589 Questions

2002 Ford Mustang
2002 Ford Mustang

617 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mustang Ford

  • Mustang Ford

Most Popular Question

both cam crank position sensors only

  • Cars & Trucks
Loading...