20 Most Recent 2011 Chevrolet Equinox - Page 3 Questions & Answers

see if this link shows you. Where is the onstar fuse on 2011 equinox Google Search

https://www.google.com/search?q=Location+of+camshaft+position+sensor+on+2001+Mitsubishi+Montero+LIMITED+3.5+ltr&biw=1366&bih=651&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwj7-rSW6p_QAhWIRyYKHcseBkIQsAQIHQ#tbm=isch&q=Transmission+fluid+level+chevrolet+equinox+2011 Hope this helps

Where is top or bottom?

Check and see if the backup lights work, if the lights don't come on then the camera doesn't get signaled to come on.

Did you get an answer to this question? Our 2014 Equinox is "beeping" from under the hood after shutting it off. Also seems to have started only during COLD weather. No it doesn't have anything to do with steering or suspension components. It is an audible beep noise or chirp noise. Thanks in advance.

Did you put deisil in it?

What year? which engine? how many miles? any Check Engine Light or Error codes from the OBD?

Chevy Equinox 2010 2011 2012 Factory Service Workshop repair manual get your car fix right now

Check the gauges fuse.

Defrost has been stronger on all types. Just the way plenums are made. Clear that wind shield first. As long as you have plenty of heat to keep the cabin area warm to hot, it's OK. I wouldn't woory about it.

Most GM models have not used a fuel filter since 2004.

Usually rotten egg smell indicates catalytic converter problem.

It depends on what kind of spark plugs are being replaced, are the old ones platinum plugs? The platinum plugs say every 100,000 miles but I don't wait that long usually. What do the old ones look like? Are you burning excessive oil, or fuel, how is the overall performance of the vehicle. Also why is the reason you're replacing them? Did the check engine light tell you to replace them or did the poor performance of the engine tell you to replace them?

yes they burn out over time

PCB Relays This vehicle is equipped with the following printed circuit board PCB mounted relays. • High beam • Low beam • DRL • Fog lamp • Park lamp • Stop lamp • Horn relay They are directly soldered to the underhood fuseblock circuit board. A failure of one of these relays will require the whole under hood fuse block to be replaced. Turn Signal/Hazard Lamps The body control module (BCM) is responsible for controlling the turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, the BCM receives a signal from the hazard switch. The BCM then will send an on-off voltage signal to all the turn signal lamps. All the turn signal lamps will flash including both IPC turn signal indicators. Vehicles are just not the same as they use to be. Electronics !!!!!

Have you checked both computers for trouble codes ?

Check to make sure it's water and not anti freeze, if it is then the heater box is leaking...If it is just water then you have a bad seal around the windshield or the door seal is leaking..Check the seal around the door to see if it's torn or come loose. Maybe get in the car and have someone squirt the door area and windshield, with a garden hose, maybe you can see where it's come in at.