20 Most Recent 2008 Nissan Xterra Questions & Answers

Hi. For the specific intention of answering your question. Number 36 and 37 are both involved in your vehicles parking lights. I must caution you not to piggy back onto fuses. Jumping power from an already established circuit is not recommended unless you are trained. Adding a load to preexisting circuits can cause them to overheat. This can cause damage or a fire. Good Luck.

it should be negative ground

It will be on the dashboard usually looks like a padlock. The ecm needs to be coded to the key and possibly to the car other ecus and dashboard as that is usually the canbus controller . If u have only changed the ecm the car will not start

Inspect the key for wear, or try another key. This is the most likely problem.

Yes. On P/finder and Xterra you will have to have the steering angle sensor reset by the dealer. This is very simple and take about 5 min so don't let them charge $100 plus if you can bargain.

EVAP Cntrl. System purge valve C fault code p 0443

In some vehicles, the fuse that controls the external mirrors is the same fuse that looks after the Cigarette lighter, and in some models the car radio.

If your cigarette lighter is not working check all of the fuses individually to find the blown one. Also on the rear of some cigarette lighters there is a fusable link type fusing wire. This has a wire similar to the older type house fuses, this melts when a short circuit occurs. When this happens the circuit is not complete. This type of lighter is found on some Toyota's and may have made it's way into Nissan's as well. Can't hurt to check it out.

nox gas to high or bad fuel. octane to low, egr valve not operating..

If you can't fish out then you will have to remove dash.

see if you have power to the horn itself

Hi,Likely an exhaust heat shield. When the SUV is cold - after sitting for 4+ hours - crawl under the vehicle and see if any of the shields are loose that cover the exhaust pipes. If they are you can use sheet metal screws screwed into the shield and against the exhaust pipeto 'wedge' the shield so it doesn't move.GL,Td