20 Most Recent 2009 Dodge Ram Pickup 1500 Questions & Answers

Question edited for clarity. Question moved to model category. click the link https://www.google.com/search?q=2009+Dodge+Ram.+Wiring+diagram+for+fuel+injector ..

Access diagnostics codes for navisstar

check the side or bottom of the seat, there should be a leaver or a tap to pull on to release the lock latch

It sounds like you have a bad or sticking solenoid that will have to be replaced inside transmission. you can clear code by unhooking battery 5 min., but this method you could loose info like, radio settings, anti theft, etc. press the helpful button

the computer gets faults readings from the sensors like speed and out put sensor

check the fluid level in the transmission it could be low

I would do a google search on the radio for a manual. Usually you can download an adobe manual onto your computer for future reference.

over full ?was truck ever submerged in water? have you changed fluid ? or front dif building to much internal heat and in turn needs a place for expansion so it is coming out vent

Yes.

The mode door actuator is bad and is the clicking sound that is being heard.

Take it to the dealer, Major job for most people.

dust causing it to overheat tripping the thermal cutout

The alarm going off is normal. Yes it will quit when it is fixed. Things to check first before you buy another door latch. First , unplug the plugs and plug them back in, see if it works. Corrosion make them loose contact. Next would be checking for power and ground at the plug. You will have to cycle the locks to check for this. If no power or ground. Then at the front of the door jam, you will see a rubber boot. It pops off both sides. This usually where wires break.

check for power at the door lock actuator..if it has power when activated replace it it is normal for the alarm to go off as the actuator and alarm switch are seperate circuits

if problems with hard start check heating coil in the intake side left on engine no spark plugs please dont even go to autozone n ask u look like a fool

Your blend air door is stuck in the open position its vacuum controlled the valve could be bad, or a vacuum hose leaking, cracked or broken off..

i was lookin at 1 of these the other day. the source is in the book that came with t he truck. an wat bulb r u talkin about? chk the book. lol!

Check high beam fuse, refers to owner manual for fuse map. If fuse ok, remove high beam bulb, don't break anything, look the filament for breakage, yes you can see it, replace bulb.