X2 Computers & Internet - Recent Questions, Troubleshooting & Support

take the matter up with just answer as fixya site has nothing to do with them most sites have a contact us right at the very bottom of the page in small writing and it is an e-mail contact

need more info bios code,windows code,windows op serial code? please be detailed

Access code for what?

Start Run cmd In command window type ipconfig /all The physical address of 6 pairs of characters is your MAC.

If you are referring to the power up access code screen that comes up when you first turn on your computer, it can be erased by removing the disc type button battery located on your motherboard. Make sure computer is un pluged from the power source. Remove the button battery for 30 seconds. Re-install it and power the computer up. It will boot up normally. If you are referring to a lock out of your Operating System, you will need to purchase a password recovery / reset program and load it into your computer during start up using the boot drive options selections located in your start up / set up menus. Its usually called: Boot Options or Boot Drive Options

The processor upgrades available to you depend on your particular system; in particular, the motherboard hardware and BIOS installed by your computer manufacturer. They do not depend on the processor you already have. 20.April.2014

orange light stably

It may have dying power supply DC filter caps just like the rest of failed monitors here:

Failed TV and Monitors: http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague Capacitors kit: http://lcdalternatives.auctivacommerce.com/ he can make you a set of caps for you. Please post back what you find.

Straighten a paper clip and push it inside the small hole just above the open/close button while you press the button. You'll need to apply some force. This is usually caused when the gear inside the cd/dvd rom is not working properly or damaged. Good luck. Thanks for using FixYa.

17"?, may be not, it may be a learning tool on electronics repair.
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://en.wikipedia.org/wiki/Capacitor_plague

http://www.badcaps.net