I DID A FACTORY RESET AND NOW IT IS STUCK ON THE SCREEN THAT SAYS WIPING DATA... FORMATTING/DATA.. HOW CAN I FIX IT
It is stuck in a boot loop for some reason - the only way to fix it now is to connect it up to a pc and use adb to reprogram to fix the partitions etc and that doesnt usually succeed so I am afraid you would be better sticking it on ebay for sale as spares or repairs - someone may need the screen.
If you have tried the pinhole reset and then the power and up volume button to factory restore anbd it doesnt work you are at a stage where you need technical assistance way beyond anything most repair shops can do - some of these problems can only be sorted by the factories that produce them or by removing and resoldering surface mounted chips onthe motherboard (ie firmware).
7/11/2015 2:32:48 AM •
Nabi 2
•
Answered
on Jul 11, 2015
How can I "thaw it out"?
Please more details on any responses from the device. Have you tried to remove/insert battery (if that one is detachable)? How does it behave when you try to turn it on while connected to wall charger? How that started?
6/7/2015 11:33:02 PM •
Nabi 16GB...
•
Answered
on Jun 07, 2015
It wont turn on when charging the red light is on for abut 4hours and then turns green i unplug it and it wont turn on ive holding down the volume + and power button and still nothing
tablets are designed to be throwaway.
you can buy new batteries off ebay but replacing the battery will require cutting and soldering as the batteries in these tablets are soldered directly to the board and are stuck in place with glue and electrical insulating glass tape. Not a big job but fiddly and anyone with a soldering iron skill and basic leccie-tronics can do it.
it may be the battery - when you press the power button does the screen flicker or does the green power light come on.
pressing the power button whilst pressing the up or down volume button should take you into recovery mode - do this whilst the power block is plugged in - if the tablet shows signs of life with the power block plugged in you can be sure its the battery..
when tablets are vroken its usually by being dropped and this can cause the screen connector to come loose so you get no display but power lights will still be on.
4/26/2015 11:53:04 PM •
Nabi 2
•
Answered
on Apr 26, 2015
Forgot password
There are two possibilities: run Hiren's CD or rewrite the OS
3/2/2015 6:38:17 PM •
Nabi 2
•
Answered
on Mar 02, 2015
How do i charge my nabi2 if my charger hole is broken
If it truly is the connector in the Nabi, you're in a bit of a jam. But, the power cords I find are very finicky. I have two Nabi's and each has its "preferred" charging cable. One cable works better than the other on each tablet. Before attempting any major repair, try another USB charging cable. You can get the cable for under $4 on Ebay. Make sure you have a high powered USB source (2 Amp or 2000 milliamp) or it won't provide enough juice to charge the tablet. Beyond that, I also sometimes have to "position" the cable just right, twisting the connector and cable till I get the red charge light to stay on. Often this requires I fully power off the Nabi, not just put it into stand-by. Good luck.
2/27/2015 9:06:44 PM •
Nabi 2
•
Answered
on Feb 27, 2015
Not finding what you are looking for?
