Electrolux Heating & Cooling - Recent Questions, Troubleshooting & Support
Kelvinator window air conditioner repair
it can damage the motor solenoid. looks similar to these
power goes into the capacitor and turns the motor on at a steady speed and builds up power, if it overloads that can happen it will either send full voltage that the motor cannot build up on or no voltage
Getting f2 error
Indoor pipe sensor (thermistor) fault. These are cheap and easy to replace.
Can u tell me how
Remote screws holding front panel on the head unit. There are usually 2 - 4 at the bottom of the louvers (for a split system) and possibly a couple under the panel that hides the filters. The whole front panels should then be able to easily lift up from the bottom and un-clip from the top.
DO NOT FORCE it if it doesn't come off fairly easily, as the plastic will break. Check that you haven't missed any screws.
Once the panel is off (make sure power is off to the whole unit) just un-clip the Rx board from the controller and plug in the new one. The Rx board may also be held by screws or just plastic clips.
Not finding what you are looking for?