Champion Garden - Page 5 - Recent Questions, Troubleshooting & Support


Briggs and Stratton Valve Clearances


outdoorpowerinfo.com/engine_specs/briggs_valve_gaps.asp

Intake and Exhaust Clearances for Briggs & Stratton engines used on a variety of outdoor power equipment ... Model Series, Engine Type, Intake Valve Clearance ( in. ) ... 120000 Horizontal Shaft, OHV Single Cylinder .004 / .006 .009 / .011.

Videos as well

https://www.google.com/search?q=valve+clearance+for+a+14.5+I%2FC+OHV.+Model+280H07

Garden | Answered on Aug 13, 2019


Should have a spring or some device to pull the tensioner if its missing or something broke. May need to replace the parts. Take the model and go online and most have diagrams. Or call the dealer and see if they can send you a diagram or the local dealer and go get a diagram from them.

Garden | Answered on Aug 13, 2019


use your fingers and count them out

Garden | Answered on Aug 13, 2019


How old is the tree? Sometimes it takes several years before it begins to bloom. I have a potted Meyers Lemon that I move inside in the winter and outside in the summer. It didn't bloom for the first 5 years I had it and it finally did in the 6th season.

Garden | Answered on Aug 10, 2019


I normally don't. I have discovered that when you soak the peas you are more likely to have them not germinate. The only time I do recommend soaking is in the very early spring. Not now when the soil is at optimum temp.

Garden | Answered on Aug 10, 2019


Fuel starvation, if the engine has a separate fuel pump, disconnect the hose from the outlet side of the pump, crank the engine, if there is a good flow of fuel then check the fuel solenoid if fitted in the base of the carb, there shoud be an audible click when the ignition switch is turn on, failing that you have dirt in the carb, so off with the carb and clean out the fuel jets.

Garden | Answered on Aug 08, 2019


Likely carburetor diaphram has ruptured. It's not a difficult repair if you have some experience. Otherwise to the repair shop.

Garden | Answered on Aug 07, 2019


It runs, so my guess is the "bad chip" is a component within the dash module.

This type of message could be either a communications fault or a memory checksum or a true failed component. My only suggestion is to remove the dash module exposing internal components of the dash module. Anything in a socket, loosen and push back in.

You don't have a mouse issue? I hope. Look for chewed wires.

Garden | Answered on Aug 02, 2019


Contact New Holland directly to inquire.

Garden | Answered on Jul 29, 2019

Not finding what you are looking for?
Champion Logo

38 questions posted

Ask a Question

Usually answered in minutes!

Top Champion Garden Experts

Lawrence Oravetz

Level 3 Expert

10543 Answers

Vernon Taylor

Level 3 Expert

5521 Answers

john h

Level 3 Expert

22153 Answers

Are you a Champion Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...