Questions & Answers for: yamaha bear engine specs

...Yamaha WR 250 like? OFF-ROAD VEHICLES - Initial Service: Check carburetor adjustment, engine idling speed and starter operation/adjust if necessary, Change engine oil/filter, Check clutch operation, ...

...engine. the carb can stay connected hanging out of the way on its cables. 5) remove the cylinder head 6) remove any exhaust linkage covers if so equipped, and the screw holding the linkage. there may ...

...yamaha big bear atv 1998 2 wheel drive and do not know if my battery is being charged by the alternator. how do i test the alternator to see if is is opperating properly where is the alternator ...

engine noise yamaha Hi i've got a yamaha thundercat the bike runs perfect it's got alot of power it doesn't misfire or anything,i've done a major service including the timing ...

...engine. It had about 85K on it. The clearances were all pretty close to nominal. I don't know the history on the car since new so they may have been adjusted at some time in its life. IIRC the ...

...yamaha bear tracker that we boughta new carb for dont want to idle on its own and bogs down while driving. Have set to specs and done valves. Only will run with choke out. Any suggestions? Check the ...

Yamaha 250 bear tracker that will not run at wide open throttle,idles fine ,when I give it the gas, it spits and spullters,can anyone help please? I put a new after market carb on and fixed the intake

...Yamaha star 1100 Owner Manual Most likely your starter "freewheel" / "sprag clutch" (like a 1 way bearing) is worn out. You'll need to remove the engine flywheel cover, the flywheel itself. The part ...